1.
A Study of Burr Fillister Sizes as well as the Minimum Fillet Radius of a Final Forging Die with the Finite Element Method
毛边槽尺寸与终锻模最小圆角半径的有限元法研究
2.
Rounded-entry driveway. Corner radius can be specified.
入口为圆角的车道。可指定拐角的半径。
3.
DETERMING THE MINIMAL RADIUS OF BASE CIRCLE OF A CAM WITH TRANSLETINGA POINT FOLLOWER ACCORING TO THE ALLOWABLE PRESSURE ANGLE[α]
按许用压力角(α)确定直动从动件盘形凸轮机构凸轮最小基圆半径
4.
Indexable hard metal (carbide) inserts--Corner radii
GB/T2077-1987硬质合金可转位刀片圆角半径
5.
Drag onto the page. Right-click to edit fillet radius.
拖到绘图页上。右击可编辑圆角半径。
6.
Radii under the head of bolts and screws
GB/T3105-1982螺栓和螺钉的头下圆角半径
7.
Roundness depends on the sharpness or radius of curvature of the edges.
浑圆度取决于边角的锐度或曲率半径。
8.
Calculation of Pressure Angle and Minimun Average Cylinder Radius of Cylindrical Cam Mechanisms with Oscillating Roller Follower by Using Instantaneous-center Method
用瞬心法求滚子摆动从动件圆柱凸轮机构压力角和最小平均圆柱半径
9.
The radius of curvature of the highlighted face is too small for blend to fit. Try a smaller blend radius using Info/Minimum Radius.
如果因为面的曲率半径太小而不能创建圆角，则会发生以下错误。高亮显示有问题的面。
10.
A 8mm Wave Multimode Conical Feedhorn With Changing Flare Angles and a Step of Radius
一种8毫米波变张角、半径突变多模圆锥馈源
11.
Two inequalities about radius of escribed circle and bisector of angle;
关于旁切圆半径和角平分线的两个不等式
12.
Determination of transitional fillet radius for hydroformed workpiece under wall thickness constraint
以壁厚约束的内高压胀形件过渡圆角半径确定
13.
Application of Changing the Radius to Compensate Macro Program in Contour Fillet
变半径补偿宏程序在轮廓倒圆角中的应用
14.
double radius button head snap
双半径半圆头铆钉窝子
15.
A radian is the angle subtended by an arc of a circle whose length is just equal to the radius.
一弧度就是长度刚好等于半径的一段圆弧所对的圆心角。
16.
Research on Method to Confirm Minimum Radius of Circular Curve of Mountain Expressway;
山区高速公路圆曲线最小半径确定方法的研究
17.
the unit of plane angle adopted under the System International d'Unites; equal to the angle at the center of a circle subtended by an arc equal in length to the radius (approximately 57.295 degrees).
国际单位制采用的平面角单位；长度等于半径的弧所对的圆心角。
18.
Application of Angle Gauge on Elliptical RT for Small Diameter Welding Tubes
角度指示计在小径管焊缝椭圆透照中的应用