1.
On Layout for Progressive Blanking Die Based on UG Secondary Development;
基于UG二次开发的冲裁级进模排样研究
2.
Experiment investigation on blanking fracture surface quality in high-speed & precision progressive stamping
高速精密级进冲压中的冲裁断面质量实验研究
3.
Reasons and Solutions of the Waste Materials Palpitation in the Progressive Blanking Processes
级进冲裁中跳屑现象的原因与解决方法
4.
Design of Progressive Die with Side Notching and Horizontal Blanking for Drawing Part
侧冲缺口-横向冲切落料拉伸级进模
5.
Progressive Stamping Simulation and Mold Design for Load Cell
负载盘级进冲压成形仿真及模具设计
6.
Stamping Process and Progressive Die Design for the Electrical Equipment Shell
电器外壳冲压工艺分析与级进模设计
7.
Improvement on stamping technique for external chain plate and development of progressive die
外链板冲压工艺改进与级进模设计制造
8.
MATHEMATICS MODEL OF CONCURRENT DESIGN FOR LIFE OF PROGRESSIVE DIE
面向寿命的级进冲模并行设计的数学模型
9.
Research on Influence of Sheet Carrier on Stamping Process of Multi-Position Progressive Die;
多工位级进模冲压载体形式对成形精度的影响
10.
Both the structure of die without punch guidance and protecting jacket are analyzed, and opinions that intensity of blanking small punch should be verified are concluded.
对无凸模导向和保护套的模具结构进行分析,提出冲裁小凸模强度核算应考虑的问题。
11.
The structure and composition of work area of blanking lower die were discussed in this paper.
讨论了冲裁凹模工作部分的结构组成。
12.
An Experimental Study and Numerical Simulation on Dual Positive Clearance Blanking;
双重正间隙冲裁试验研究及数值模拟
13.
Study on Contact-impact Dynamic Response of the Die in Sheet Metal Stamping;
板料冲裁过程中模具的碰撞响应研究
14.
Development of Cutting Die Design System on the Basis of Solid Works;
基于Solid Works的冲裁模设计系统开发
15.
Mechanism of Small Hole Punching on Thick Blank and Study on Die Life-span;
厚钢板小孔冲裁机理及模具失效研究
16.
A Discussion on Die Press-center Location by Using AutoCAD;
利用AutoCAD求解冲裁模压力中心的探讨
17.
The prediction of the punch wear based on the analysis of the shearing surface
基于剪切面分析的冲裁模具磨损预测
18.
Plan of Scrap Iron Treatment of Cold Stamping and Trimming Die for the Auto-Cover
汽车覆盖件冲裁修边模铁屑处理方案