1.
Analysis Modeling and Control of Networked Control Systems;
网络控制系统的分析建模与控制研究
2.
The Analysis, Modeling and Control for Descriptor Networked Control Systems;
广义网络控制系统分析、建模与控制
3.
Modeling and Control of the Interception Missile by Combined Control of Lateral Thrust and Aerodynamic Force
直接力与气动力复合控制拦截弹建模与控制
4.
Research on Modeling and Control of 1500 Temper Rolling Mill Force System
1500平整机轧制力系统建模与控制研究
5.
Modeling and Controller Design for NCS over IP Network;
基于IP的网络控制系统建模与控制器设计
6.
Motion Control of Omnidirectional Mobile Manipulators (PartⅠ)--Modeling and Control
全方位移动机械手运动控制Ⅰ——建模与控制
7.
Identification and Control of Thermal Process Based on T-S Model;
基于T-S模型的热工系统模糊建模与控制
8.
Modelling and Control of the Quasi-Homogeneous Lean Burn Engine;
准均质稀薄燃烧发动机的建模与控制
9.
Plant Modelling and Sliding Mode Control for Networked Control System;
网络控制系统的对象建模与滑模控制
10.
Modeling, Stability and Control of Networked Control Systems;
网络控制系统的建模、稳定与控制研究
11.
The Modeling and H_∞ Control of Cold Tandem Tension Control System;
冷连轧张力控制系统的建模与H_∞控制
12.
Models and Simulations of On-ramp System under Signal Controlling;
信号灯控制入匝道系统的建模与模拟
13.
Modeling and Simulation of PWM Rectifier Based on Sliding-Mode Control
基于滑模控制的PWM整流器建模与仿真
14.
Modeling and Simulation of Autocar Braking System and ABS Control Strategy;
轿车制动系建模与仿真及ABS控制策略
15.
Modeling and Simulation of Simple Guided Mortar Using Impulse Thruster Control
简易制导迫弹脉冲力控制建模与仿真
16.
Research on Network Model and Congestion Control Mechanism Based on Control of Transmission Rate;
基于速率控制的网络建模与拥塞控制算法研究
17.
Research on Modeling and Robust Control Problem of Networked Control Systems;
网络化控制系统的建模与鲁棒控制问题的研究
18.
PI Controller--Mode and Simulation for a Control System to Remove Jam;
PI控制器-控制系统消除扰动的建模与仿真