1.
tightening bolt
拉紧螺栓，(铁)风口拉杆
2.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
3.
Two Ways of Calculating General Pulling Force of Tight Screw Bolt Linking with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力的两种计算方法
4.
Studies on the Ways of Calculating General Pulling Force of Tight Screw Bolt Lin king with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力计算方法研究
5.
Improper bolt tightening procedure.
螺栓拧紧程序错误。
6.
maneton clamp bolt
可拆卸曲柄颊夹紧螺栓
7.
square collar-head set-bolt
方头凸缘端紧定螺栓
8.
" Tolerances for fasteners--Bolts, screws and nuts"
GB/T3103.1-1982紧固件公差螺栓、螺钉和螺母
9.
LOWER TRACK BAR BOLT INSTALLATION
下横拉杆螺栓的安装
10.
a hand tool that is used to hold or twist a nut or bolt.
用来上紧或扭螺母或螺栓的手工具。
11.
Fasteners--Clearance holes for bolts and screws
GB/T5277-1985紧固件螺栓和螺钉通孔
12.
" Mechanical properties of fasteners--Bolts, screws and studs"
GB/T3098.1-1982紧固件机械性能螺栓、螺钉和螺柱
13.
hydraulicdevice for tightening tie-bolt
贯穿螺栓上紧用液压装置
14.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈
15.
Engine Cylinder Head Bolt Tightening Sequence
引擎汽缸头螺栓锁紧顺序
16.
Install the seat/shoulder belt anchor bolt.
安装座椅/安全肩带系紧螺栓。
17.
Replace the body bolts and tighten evenly.
重新放置阀体螺栓，并均匀紧固。
18.
Tighten the engine mount-to-bracket bolts.
拧紧引擎架至支架的螺栓。