1.
Study on the Boundary Condition of Inlet Oil Temperature of Energy Equation for EMP Pad by Boundary Layer Theory
利用边界层理论确定弹性金属塑料瓦油膜能量方程的进油温度边界条件
2.
Analysis of Thermal Boundary Condition and FEA Calculation of Temperature Field for the Exhaust Valve of Diesel Engine
排气阀热边界条件分析及温度场有限元计算
3.
Influence of Material Models and Boundary Conditions on the Temperature Field of Steel-Concrete Composite Sections
材料模型和边界条件对组合截面温度场的影响
4.
Influence of boundary conditions on temperature distribution in the diesel piston
边界条件对柴油机活塞内温度分布计算的影响
5.
Numerical Analysis of Diesel Engine Piston Temperature Field by Axisymmetric BEM
用边界元法对活塞热边界条件及温度场分布的研究
6.
In this paper, the temperature field boundary conditions and the temperature loads calculation for this arch dam are described.
本文介绍了坝面边界条件和温度荷载的计算情况。
7.
Two Theoretical Temperature Solutions of a Concrete Lift with the Dirichlet Boundary Condition
混凝土浇筑层温度场在第一类边界条件下的计算
8.
The boundary layer thickness is a function of the convection condition, in the melt.
边界层厚度是溶体中对流条件的函数。
9.
AN EXTENDED SECOND ORDER SLIP BOUNDARY CONDITION FOR MICRO FLOWS
微尺度流动的扩展二阶滑移边界条件
10.
In general we can have temperature or flux boundary conditions but in this case we will only consider the former.
一般说，边界条件可以是给定温度，也可是给定热流，但这里我们只考虑前者。
11.
The temperature value for the pivotal dots is obtained through data processing according to the determined boundary conditions.
对于给定的边界条件进行了数据处理，得出了关键热源点上的温度值。
12.
Thus, a broad range of wetlands are subject to the permit requirement.
因此，沼泽地的宽阔边界以需要限度为条件。
13.
On the Navier-Stokes Equation of Vorticity Type with a Slip Boundary Conditions;
带有一类Slip型边界条件的旋度型Navier-Stokes方程
14.
STUDY OF THE IMPACT OF THE VELOCITY INLET BOUNDARY CONDITION TO THE BUBBLING FLUIDIZED BED
速度进口边界条件对鼓泡床流动影响研究
15.
iterative fulfilment of boundary conditio
边界条件的迭代实现
16.
Electromagnetic field boundary conditions on moving interfaces in high frequency case
高频条件下运动边界的电磁场边界条件
17.
A Review of the Surface Boundary Conditions for Temperature and Salinity of Oceanic General Circulation Models
大洋环流模式的温盐表面边界条件处理及其影响研究评述
18.
While at the corner there are corner conditions: deflection or reaction also.
沿每个边有两个边界条件：挠度或等效剪力，斜度或弯矩应分别等于沿边界的已给值。