1.
Numerical Simulation and Experimental Research on Dynamic Fracture of Three-Point Bending Specimen;
三点弯曲试样动态断裂的数值模拟与实验研究
2.
Study on three points bend specimen natural frequency by using ANSYS
基于有限元的三点弯曲试样固有频率研究
3.
Table 4. 1 for three-point bend specimens shows that the ratio of support span to specimen depth has a small but definite effect on the results.
表4．1的三点弯曲试样表明，支撑跨距对试样高度的比值对试验结果有微小而又确定的影响。
4.
Plastics--Determination of flexural properties by use of small specimens
GB/T16419-1996塑料弯曲性能小试样试验方法
5.
DISCUSSION ON CONTACT SITUATION OF SPECIMEN WITH SUPPORTS IN HOPKINSON BAR THREE-POINT BENDING TEST
Hopkinson杆三点弯曲试验中试样与支座接触状态分析
6.
Specimen for surface crack growth by loading at cantilever bend and application
一种悬臂弯曲加载表面裂纹扩展试样及其应用
7.
Figure 3, 4 shows a flat piece of metal that has been through an angle of 180. Sheet metal may be given a single bend test
图3．4表示一片金属扁试样被弯曲180°可以对薄板金属进行单向弯曲试验，
8.
A part that is curved or bent like a hook.
弯曲部分象钩子一样弯曲的部分
9.
curved down like an eagle's beak.
象鹰嘴一样向下弯曲的。
10.
alternative wrap around guided-bend test
交变缠绕定向弯曲试验
11.
flexing ozone weather testing chamber
臭氧腐蚀弯曲试验箱
12.
testing method for flexing endurance of light leathers and their surface finishes
皮革耐弯曲性试验方法
13.
testing method for flexural creep of plastics
塑料弯曲蠕变试验法
14.
rotary bending tester
旋转弯曲疲劳试验机
15.
rotating bending fatigue machine
回转弯曲疲劳试验机
16.
reversed bending fatigue machine
反复弯曲疲劳试验机
17.
Test methods for bare wires--Bend test--Single bend test
GB/T4909.6-1985裸电线试验方法弯曲试验单向弯曲
18.
Test methods for bare wires--Bend test--Reverse bend test
GB/T4909.5-1985裸电线试验方法弯曲试验反复弯曲