1.
Primary Research about the Effect of Normalizing Process on Mechanical Property for D36 ship plate steel
正火工艺对船板钢性能影响的初步研究
2.
The microstructure and property of alloy carburizing steel forged parts after general normalizing and isothermal normalizing were studied.
研究了合金渗碳钢锻件的普通正火与等温正火工艺参数对组织、能的影响。
3.
Study on the Influenceof TMCP and Normalizing Process on Microstructure & Properties of Q370qE Stell Plates;
控轧控冷与正火工艺对Q370qE钢板组织性能影响的研究
4.
Applied Investigation on Process of Controlled Rolling and Controlled Cooling in Stead of Normalizing for High Strength Ship-plate;
高强度船板控轧控冷替代正火工艺的应用基础研究
5.
Research on New Normalizing Techniques for 20Cr2Ni4 Steel
20Cr2Ni4钢正火新工艺的研究
6.
HT Sub-factory : complete process of annealing, quenching, tempering, quenching and tempering, solution treatment etc.
热处理厂：可完成退火,正火,回火，调质,固溶处理等工艺.
7.
Study on the Kinetic Mathematical Model of Normalization in Ductile Iron and Optimization of Process;
球铁凸轮轴正火动力学数学模型研究及其工艺优化
8.
The Quenching Procedure Test of SA387Gr11CL2
SA387Gr11CL2钢淬火工艺试验
9.
Research on Sub-temperature Quenching Process of 30CrMnSiA Steel
30CrMnSiA钢亚温淬火工艺研究
10.
Research on Heat Treatment Technology of 5CrMnMo Hot Forging Die
5CrMnMo热锻模淬火工艺研究
11.
A brief introduction to quenching-partitioning-tempering (Q-P-T) process
淬火-碳分配-回火(Q-P-T)工艺浅介
12.
Optimization of machining parameters of EDM and its applications
电火花加工工艺参数的优化及其应用
13.
Study on the Discharge Mechanism and Technology in Powder-mixed EDM;
混粉电火花加工放电机理及工艺研究
14.
Research on Processing Law of Micro Wire Electrical Discharging Machining;
微细电火花线切割加工工艺规律研究
15.
Electrical Discharge Machining (EDM) Technological Test of GT35 Steel-bonded Carbide
GT35钢结硬质合金电火花加工工艺试验
16.
The Continuous Annealing Process for Cold-rolled Non-oriented Electrical Steel
冷轧无取向电工钢连续退火工艺研究
17.
Research on EDM Technology Experimentation of 4Cr5MoSiV
4Cr5MoSiV电火花加工工艺试验研究
18.
Brief analysis on hazards of the producing glycol and some relevant fire-control strategies;
乙二醇生产火灾危险性及工艺防火对策