1.
air admission valve
进气阀,真空破坏阀
2.
intake valve deposit control additives
进气阀防积炭添加剂
3.
a loud noise made by the explosion of fuel in the manifold or exhaust of an internal combustion engine.
内燃机的排气阀或进气阀在开启时爆染并引起大声的爆鸣。
4.
The large holes on the left and right represent the inlet and exhausting valve ports respectively.
左右两侧的两个大孔，分别表示进气阀孔和排气阀孔。
5.
Install throttle body to intake manifol
安装节气阀体至进气歧管。
6.
a safety, exhaust valve
安全阀、 排气阀.
7.
discharging valve
排出阀排气阀排水阀
8.
Remove the throttle body bolts and lift the throttle body off the intake manifolDiscard the throttle body gasket.
拆下节气阀体螺栓并举高节气阀体脱离进气歧管。扔掉节气阀体衬垫。
9.
Open the inlet water valve and press the top discharge valve to discharge the air in the filter at the same time.
打开进水阀门，同时按下顶上排气阀，使滤器内空气排出即可。
10.
Study on the Reed Valve in Intake System of K157 Engine
K157发动机进气系统单向阀的研究
11.
The Seal Structure Improvement of Multi-Seal Fuel Gas Separates
多密封燃气隔断闸阀密封结构的改进
12.
a valve through which burned gases from a cylinder escape into the exhaust manifold.
通过来自汽缸的燃烧废气进入排气集管的阀。
13.
After fitting of the valve, the valve should be maintained in a closed position to prevent any contamination from entering the cylinder.
连接好阀门后，阀门应保持关闭位置，为防止任何污染进入气瓶。
14.
Valve rotator is an important device to ensure the normal operation of the inlet and exhaust valves of a medium speed diesel engine.
旋阀机构是保证中速柴油机进、气阀正常工作的重要装置。
15.
Install throttle body to intake manifolRefer to Throttle Body installation in this section of the group.
在进气歧管上安装节流阀体。请参阅单元中本节的节流阀安装部分。
16.
snifting valve
【机】喷气[吸气]阀
17.
(knob which operates the) valve controlling the flow of air into a petrol engine
阻风门（开关）（控制进入汽油机空气量的阀门）
18.
Loose install EGR tube and EGR valve to intake manifol
将EGR管和EGR阀装入进气歧管，并保持松动。