1.
The Research of Intelligent Design for Filature Screw Extrusion Machine & Expert System;
纺丝螺杆挤压机智能设计与专家系统研究
2.
screw-melter-fed spinning machine
螺杆式熔化器喂料纺丝机
3.
PROPERTIES OF AN ORGANIC LIQUID ABSORBING FIBER PREPARED BY GELATION-SPINNING
双螺杆冻胶纺丝法制备有机液体吸附功能纤维及其性能研究
4.
cross point square blade screwdriver with plastic handle
十字塑料柄方杆螺丝刀
5.
double-purpose interchangeable tip square blade screwdriver
可换头方杆两用螺丝刀
6.
Secondly there is error between thethread roll angles of thread rolling die and drill rod.
滚丝轮螺纹和钻杆螺纹的螺旋角有误差。
7.
A staff that holds on its cleft end the unspun flax, wool, or tow from which thread is drawn in spinning by hand.
（手工）纺纱杆在杆的开裂的一端夹有未纺的亚麻、羊毛或丝束，手转动木杆，线从中纺出
8.
Loosen setscrew 4.
拧松线张力杆固定螺丝4进行调整。
9.
Remove adjuster lever, adjuster screw and spring.
拆卸调整器杆，调整器螺丝和弹簧。
10.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
11.
Your knee is being held together by a rod and three screws.
你的膝盖是被一个杆和三个螺丝铆在一起的
12.
Loosen the adjustment screw, and adjust the length of the link rod.
请拧松调整螺丝，拔出或插入连接杆进行调整。
13.
The upper stem is threaded into the diaphragm retainer nut.
上阀杆通过丝口旋在横膈膜止动螺母里。
14.
Using a trim stick or equivalent, open the end covers to access the screws.
用一根清洁杆或同等物，打开末端盖去检查螺丝。
15.
Study and Application of a New Type of Rolling Screw-nut Pair
一种新型滚动丝杆螺母副的研究与应用
16.
Remove stem nuts (22). Keep stem from turning by inserting screw driver in slot on end of stem.
拆卸阀杆螺母(22)。通过在阀杆末端的槽内插入螺丝刀来避免阀杆旋转。
17.
To replace seat/ stem module shut off supply, loosen locknut and back off adjusting screw.
要更换阀座/杆模块，先关闭供应管道，松开锁紧螺母，退出调节螺丝。
18.
Assembly consists of thumb screw, hooks, swivel joint, and stem, threaded at one end.
这种总成由翼型螺丝、钩、转接头和杆子组成，在一端上有螺纹。