1.
Key Technology Research of Meshing Micro-Motor;
啮合式微型电机若干关键技术的研究
2.
The Design of the Gearing Motor and Its Power Output Mechanism;
啮合式电机及其动力输出机构的设计
3.
Fast Nonlinear Analytical Model for a New Type of Gear Motor
新型啮合式电动机的快速非线性模型
4.
Design and Manufacture of Globoid Indexing Cam Mechanism for a New Tape of Point Engagement
新型点啮合式弧面分度凸轮机构的设计与制造
5.
Control and Simulation of a New Translational Meshing Motor;
新型平动啮合式电动机的控制方法与仿真
6.
The control and drive system of Gearing Micro-motor based on DSP LF2407A;
基于DSP LF2407A的啮合式微型电机控制驱动器
7.
whole tolerance single-side mating gear detector winch
全误差式齿轮单面啮合检查仪绞车
8.
spur geared wheel reductor
外啮合圆柱齿轮式轮边减速器
9.
Analysis on Two Structural Styles of Starter Meshing System
起动机啮合系统2种结构形式的分析
10.
Analysis on the Mesh Efficiency Sensitivity of RV Transmission
封闭差动式传动啮合效率的敏感性分析
11.
Meshing Calculation Formulas of Spatial Cam Mechanisms with Concentric Roller Followers
空间同心滚子从动件凸轮机构的啮合计算公式
12.
Strength Analysis of Globoidal Worm Gearing with Roller Teeth and Point Engagement;
滚动式点啮合环面蜗杆传动的强度分析
13.
Structure Design and Research on Fundamental Features about Translational Meshing Motor;
平动式啮合电机的结构设计与基本特性研究
14.
Dynamic analysis and torque control of translational meshing motor integrated with compliant mechanism
柔性平动式啮合电机动态分析与转矩控制
15.
Construction Principle and Static Torque of Translational Meshing Motor Integrated with Compliant Mechanism
柔性平动式啮合电动机结构原理及静态转矩
16.
To join or attach by means of a joggle.
榫接，啮合用啮合扣或接榫连接或安装
17.
A Periodically Time-varying Mesh Stiffness Model for Spur Geared System Considering the Effect of Extended Tooth Contact
考虑延长啮合时齿轮副啮合刚度模型
18.
The formulas of essential and sufficient conditions for actual double pair tooth engagement, as well as the formula of actual contact ratio, are also proposed.
提出了实际双齿啮合必要和充分条件及实际重合度的概念及公式。