1.
An aided design expert system for fit tolerance using case-based reasoning
应用案例推理的配合公差辅助设计专家系统
2.
" Tolerance and fitting, dimensions up to 500mm holes, shaft tolerance range and fitting"
GB/T1801-1979公差与配合尺寸至500mm孔、轴公差带与配合
3.
" Tolerance and fitting, dimensions up to 18mm holes, shaft tolerance range"
GB/T1803-1979公差与配合尺寸至18mm孔、轴公差带
4.
Tolerances and fits--The calculation and selection of interference fits
GB/T5371-1985公差与配合过盈配合的计算和选用
5.
A FIT CHARACTERISTIC ANALYSIS OF THE NEW 《TOLERANCE & FIT》 SYSTEM
对新《公差与配合》国家标准中配合性质的解析
6.
General purpose screw threads--Tolerances and fits for diameter from 1 to 355mm
GB/T197-1981普通螺纹公差与配合(直径1~355mm)
7.
Mechanical drawings--Indication of tolerances for size and of fits
GB/T4458.5-1984机械制图尺寸公差与配合注法
8.
Discussing the teaching of Tolerance Fiding and Technology Measurement;
“公差配合与技术测量”的教学探讨
9.
" Limits and fits--Bases--Part 2: Basic rules of tolerances,deviations and fits"
GB/T1800.2-1998极限与配合基础第2部分:公差、偏差和配合的基本规定
10.
An allowed difference in dimension of closely mating machine parts.
公差，容差机器配件的公差，容差
11.
" Tolerance and fitting, dimensions larger than 500mm and up to 3150mm ordinary holes,shaft tolerance range"
GB/T1802-1979公差与配合尺寸大于500至3150mm常用孔、轴公差带
12.
Thoughts of Teaching Reform about "Tolerance and Technical Measurement";
《公差配合与技术测量》课程教学改革的思考
13.
An Examination on Teaching "Tolerance and Fit and Technical Measurement";
《公差配合与技术测量》课程的教学与改革探讨
14.
Research to relation between tolerance of cooperating parts and service life of machine;
配合件公差与机器使用寿命关系的研究
15.
"Tolerance and technology with the basic measurement of" Curriculum Teaching
《公差配合与技术测量基础》课程教学刍议
16.
The Choice of Tolerance and Coordinate Based on Artificial NN Methods
基于人工神经网络法公差配合的优化选择
17.
Research for 《tolerance matching and measurement technology》 courseware in high vocational institute
高职《公差配合与测量技术》CAI课件的研制
18.
Limits and fits--Bases--Part 3: Numerical values tables of standard tolerances and fundamental deviations
GB/T1800.3-1998极限与配合基础第3部分:标准公差和基本偏差数值表