1.
Cracking analysis on corner-inclusive shearing fractures for rubber vibration-reduction spacers
含角裂纹剪切型橡胶减振垫的断裂分析
2.
Analysis of stress intensity factors for corner crack in section Ⅰ-beam
工字型截面梁角裂纹的应力强度因子分析
3.
3D FINITE ELEMENT ANALYSIS OF SIF OF THE STRUCTURE WITH DIMPLE HOLE
锪窝孔边扇形角裂纹应力强度因子的三维有限元分析
4.
Formation Mechanism and Prevention of Center and Triangle-Zone Cracks in Continuous Cast Slabs
板坯中心裂纹和三角区裂纹的成因与防止
5.
Research on the crack growth angles of Ⅰ-Ⅱ-Ⅲ mixed mode crack with photoelastic experiment
Ⅰ-Ⅱ-Ⅲ复合型裂纹开裂角的光弹性试验研究
6.
Study on Corner Sink and Vertical Cracks of CC Steel Billet
连铸坯角部凹陷及纵向裂纹的研究
7.
Cause of Corner Crack of Continuous Cast Billet in Laiwu Steel No.5 Continuous Casting
莱钢5号连铸机连铸坯角部裂纹成因分析
8.
Study on Transversal Corner Crack of 15Mn2CrVNb Bloom for Wagon Brake Beam Manufacturing
货运机车制动梁用15Mn2CrVNb钢方坯角部横裂纹研究
9.
Numerical Analysis of Transversal Crack on Slab Corner in Straightening During Continuous Casting
连铸矫直过程板坯角部横向裂纹数值分析
10.
Stability Analysis of a Cracked Rotor Model Based on Whirling Angle
基于涡动角的裂纹转子模型稳定性分析
11.
The effect of crack distance and fiber angle on delaminations in laminated composites
裂纹间距及铺层角度对复合材料分层的影响
12.
Large deformation bands were observed at each side of the crack.
实验结果表明：在裂尖两侧存在与裂纹方向夹角约为50°大变形带。
13.
seal-split cowhide bag
海豹纹理状裂纹牛皮袋
14.
Examine block for cracks or fractures.
测试泵体裂纹或破裂。
15.
The crack eventually caused the chord to fracture.
裂纹最终致使弦杆断裂。
16.
"Thus, there is no strong diagonal line, and the fabric is smooth-faced, with an unbroken surface made up of long floating warp yarns."
因此缎子也没有很深的对角纹路,其质地光滑,没有断裂处。
17.
It was concluded that failure of double clip reed was the result of local stress concentration and cracking at the sharp elbow of reed.
双卡簧片成形时弯角较尖锐并有明显裂纹是导致失效的原因。
18.
A segment of the box corner was removed with a hole saw in order to permit an examination of the crack.
为了对裂纹进行检查，用圆孔锯从箱型断面拐角处锯下一部分。