1.
Out-of-Plane Bending Moment Analysis of the Plastic Limit for the Welded Piping Tee Containing Bottom Thinning Defects
底部减薄焊制三通的塑性极限面外弯矩分析
2.
Sectional Capacity of Rectangular Hollow Section under Combined Loading
矩形管截面塑性极限承载力相关关系
3.
The Plastic Limit Analysis of Circular Plates Under Edge Moments and Local Linear Load
在边缘弯矩和局部线性荷载共同作用下圆板的塑性极限分析
4.
Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment
面内弯矩下双弯头组合管件的极限载荷研究
5.
Plastic Limit Load Analysis of the Gas Elbow Pipe with Pitting Flaws
含点蚀缺陷燃气弯管塑性极限载荷分析
6.
Ultimate negative bending-moment capacity of outer-plated steel-concrete continuous composite beams
外包钢-混凝土连续组合梁的负弯矩极限承载力(英文)
7.
Elastic-Plastic Finite Element Analysis for Circumferential Part-Throughwall Cracks on Mitered Elbow;
斜接弯管环向内表面裂纹弹塑性有限元分析
8.
Elastic-Plastic Finite Element Analysis for Piping Elbow with Axial Inside Surface Cracks;
光滑弯管沿轴向内表面裂纹弹塑性有限元分析
9.
Analysis and Experiments on the Plastic Limit Load of Elb ows with Local Thinned Area under Internal Pressure
内压作用下局部减薄弯管塑性极限载荷分析与试验研究
10.
Research on Plastic Limit Load of Local Thinning Elbow for Engineering Calculation Method;
含局部减薄弯管塑性极限载荷工程计算方法研究
11.
Analysis of Ultimate Load of Elastic-Plastic In-plane Cable-Arch;
索一拱结构平面内弹塑性极限承载力研究
12.
3D plasticity limit analysis of hexahedral sliding wedge for rock slope
岩质边坡六面体滑楔的三维塑性极限分析
13.
Then, the compound method is used to assess the hull girder ultimate strength reliability of a bulk carrier subjected to extreme bending moments.
最后，基于极限强度，将该组合方法用于评估散货船在极值弯矩作用下的船体梁安全性。
14.
Limit Analysis of Pressure Vessels with Pad Reinforcement under In-plane Moment on Nozzles;
接管纵向弯矩作用下带补强圈容器的极限分析
15.
A Study of Limit Load for Cylindrical Shells with Reinforcement Pad under Nozzle Moment;
接管弯矩作用下容器补强结构极限载荷的研究
16.
Limit Analysis for Cylindrical Shells with Opening-reinforcement under In-plane Moment
接管纵向弯矩下带补强圈容器结构的极限分析
17.
DISCUSSION ABOUT MOMENT MODULATION COEFFICIENT OF ULTIMATE EQUIVALENT LOAD BALANCE METHOD
极限等效荷载平衡法弯矩调幅系数探讨
18.
The Test and Theory Study in the In-Plane Stability Capacity of Hot-rolled H-section Columns under Eccentric Load;
热轧H型钢偏心受压构件在弯矩作用平面内极限承载力的理论与试验研究