1.
Drive Control System of WRB and FRS for New High Speed Roll Mill in Xianggang
湘钢新高线精轧和减定径机组传动控制系统
2.
Application Research on Optimized Wire Rod RSM Rolling Parameters by DOE
运用试验设计优化高线减定径机组轧制参数的应用研究
3.
RSB Technology-Innovative and Reliable Special Bar Quality Production
减定径机组[RSB]技术—创新性的特钢棒材可靠生产方式
4.
Design for Improvement of Finished Tube Pass for Stretch Reducing Mill of Φ89 mm MPM Plant
Φ89mm连轧管机组张力减径机成品孔型的改进设计
5.
Characteristic and Design of Grouping Centralize Differential Surface-driven Stretch Reducing Mill
分组集中差速外传动张力减径机的特点和设计
6.
An Implementation of the Fault Diagnosis Expert System of the Reducing and Sizing Block on High-Speed Wire and Rod Production Line
高线生产线减定径机故障诊断专家系统的实现
7.
COMMON IMPERFECTIONS AND PRECAUTIONS OF SIZING MILL IN 340MPM
340MPM连轧管机组定径机区域常见缺陷及预防措施
8.
Brief Introduction of SRM330-24 Stands Stretch Reducing Mill
SRM330-24机架张力减径机简介
9.
A FORMULA FOR DETERMINING THE RELATION BETWEEN DIAMETER REDUCTION AND WALL REDUCTION IN TUBE-COLDDRAWING
确定冷拔钢管减径量与减壁量之间关系的公式
10.
Mechanical vibration of non-reciprocating machines--Measurements on rotating shafts and evaluation criteria--Part 4: Gas turbine sets
GB/T11348.4-1999旋转机械转轴径向振动的测量和评定第4部分：燃气轮机组
11.
The vibrator and frame are connected and fixed up and down with the buffer by six groups of soft rubber.
振动部与机体座有六组软橡减振器上下连接固定。
12.
Group FEM Model for Tube Shape Prediction of Stretch Reducing Process
张力减径过程管形预测的分组有限元模型
13.
Comparison on Transmission Styles of Stretch-reducing of Tubes
张力减径机双电机集中传动方式的比较
14.
The research and development of the generator mount about 1.5 MW wind turbine
1.5MW风力发电机组发电机减振器的研制
15.
Roeckner tube rolling mill
罗克内尔式大口径管材壁厚减薄用轧机
16.
Analysis on Electric Drive Plan of the Individual Drive Slight Stretch-Reducing Mill
单独传动微张力减径机电气传动方案的分析
17.
Development and Application of Automation Control System of φ460mm (Slight) Stretch Reducing Mill
φ460mm微张力减径机自动控制系统的设计及应用
18.
Design of Under-Frequency Load Shedding Schemes Using Combinatorial Optimization
基于组合优化的低频减载方案的整定