1.
MATHEMATICS MODEL OF CONCURRENT DESIGN FOR LIFE OF PROGRESSIVE DIE
面向寿命的级进冲模并行设计的数学模型
2.
Design of Progressive Die with Side Notching and Horizontal Blanking for Drawing Part
侧冲缺口-横向冲切落料拉伸级进模
3.
Progressive Stamping Simulation and Mold Design for Load Cell
负载盘级进冲压成形仿真及模具设计
4.
Stamping Process and Progressive Die Design for the Electrical Equipment Shell
电器外壳冲压工艺分析与级进模设计
5.
Improvement on stamping technique for external chain plate and development of progressive die
外链板冲压工艺改进与级进模设计制造
6.
Research on Influence of Sheet Carrier on Stamping Process of Multi-Position Progressive Die;
多工位级进模冲压载体形式对成形精度的影响
7.
On Layout for Progressive Blanking Die Based on UG Secondary Development;
基于UG二次开发的冲裁级进模排样研究
8.
Study on Design and Optimization of Stamping Force and Pressure Center for Progressive Die;
级进模冲压力和压力中心的确定及优化方法研究
9.
The quality control technique based on rough set theory for stampings made by multi-position progressive dies
基于粗糙集理论的多工位级进模冲件质量控制方法
10.
High-precision progressive stamping process with multi-way co-feeding in parallel
多向同步进料精密级进冲压工艺探讨
11.
Experiment investigation on blanking fracture surface quality in high-speed & precision progressive stamping
高速精密级进冲压中的冲裁断面质量实验研究
12.
An Improved Two-Stage Processing Approach of Adaptive Monopulse at Subarray Level
一种改进的两级子阵级自适应单脉冲方法
13.
Design of Transition-control Module for Integral Solid Rocket-ramjet
整体式固冲发动机转级控制模块设计
14.
Design and Analysis of a Single-stage Long Pulse LTD Module
单级长脉冲LTD模块的设计及分析
15.
Homological Properties of Graded Wn-module and Graded n Degree Syzygy Module;
分次W~n—模与分次n级合冲模的同调性质
16.
Reasons and Solutions of the Waste Materials Palpitation in the Progressive Blanking Processes
级进冲裁中跳屑现象的原因与解决方法
17.
Abstract: The discrete element method( DEM) model of two-level isolation system impacted by external force is developed.
文摘:提出了外力冲击的二级隔离系统的DEM模型。
18.
Numerical Simulation and Experimental Verification of Hydraulic Performance of Stamping Multi-stage Pump
冲压式多级泵水力性能的数值模拟及实验验证