1.
Study on the On-line Test Technology of Weld Width in Metal Bellows;
金属膜盒焊缝宽度在线检测技术研究
2.
Image Edge Processing Method of Radiographic Testing for the Width Measurement of Micro Weld
用于微焊缝宽度测量的射线检测图像边缘处理方法
3.
And the weld width decrease with welding speed being increased.
而焊接速度的增大,焊缝正面和背面的熔宽明显减小。
4.
The spcimens were machined such that plug weld was centered on the width of the specimen.
对试件进行了机加工以使塞焊焊缝位于试件宽度中间。
5.
With fine ability to clear off oxidation film, The width of clearing film can be adjusted continuously to make out good-looking welding seam.
超强清理氧化膜能力，清理宽度连续可调，焊缝光亮美观。
6.
slot length and width of bubble cap
泡罩齿缝长度与宽度
7.
Indicates concave, convex or flush welds. Increase height to fit above other weld symbol.
指示凹焊缝、凸焊缝或平焊。增加高度以配合其他焊接符号。
8.
Regression and Analysis on Metal Strength of Welding Seam of Welding Core Wine
药芯焊丝焊缝金属强度的回归与分析
9.
Study of Length Calculation of Three Side Welded Lap;
三面围焊搭接角焊缝长度计算的探讨
10.
The width of the seam allowance used determines the width of the welt.
留出缝份,缝份的宽度根据贴边的宽度而定。
11.
The width varies depending on the area where the seam is desired.
缝份的宽度按所需缝线的部位而定。
12.
As for welding seams of the same heat treatment state, the hardness of welding seam area depends on different welding wires.
对于同一种热处理状态的焊缝,焊缝区的硬度取决于不同的焊丝。
13.
Transfer Behavior Study in Weld Thickness Direction of the Welding Plastic Metal in Friction Stir Welding
搅拌摩擦焊焊缝塑性金属在焊缝厚度方向的迁移行为研究
14.
"Where thickness characteristics at the joint are more important than strength, a thinner welder is possible at reduced joint strength. "
如果焊缝的厚度比强度更重要,则在降低强度条件下可使焊缝更
15.
Welding Procedure and Welded Seam Tracking and Pool Width Control for Copper-clad Aluminum Cable Billet in TIG High-Speed Welding;
铜包铝线坯高速TIG焊工艺与焊缝跟踪及熔宽控制
16.
The Temperature Control System in HF Spiral Pipe Mill
高频螺旋焊管焊缝温度的闭环控制系统
17.
The Modelling of Temperature Control by Speed in HF Welding Pipe Process and its Temperature Control System
高频直缝焊管焊接速度控温建模及控温系统
18.
Path Planning of Six Multi-joints Robots for Line Welding
六自由度机器人在焊缝焊接应用中的路径规划