1.
An unit with Blast furnace Blower having a Common Axis Run and Analysis of it's Energy Saving
高炉鼓风机同轴机组运行与节能分析
2.
Torsional Vibration Analysis of Turbo-Generator Shaft by Electrical Grid Sub-synchronous;
电网次同步谐振下汽轮发电机组轴系扭振分析
3.
Parameters part identification of synchronous machine with quadrature-axis short-circuit winding
带交轴短路绕组的同步电机参数局部辨识
4.
axial flow hydroelectric unit
轴流式水力发电机组
5.
Research on an Axial/Radial Flux Permanet-Magnet Synchronous Machine with Folding Winding
具有折叠绕组的轴径向磁通永磁同步电机的研究
6.
The Laser Simultaneous Test System of Shafting Elevation and Its Application in Turbo-generator Units
汽轮发电机组轴系标高激光多点同时测试系统及其应用
7.
Damage of the Shaft-current to Generator Units and Shaft-current Prevention
发电机组轴电流的危害及轴电流保护
8.
Shaft Assembly (Male, female, washer, grease….
轴组件(轴,轴套,轴承,油脂。。。)
9.
Radio frequency and coaxial cable assemblies--Part 2-1: Sectional specification for flexible coaxial cable assemblies
GB/T15866-1995射频同轴电缆组件第2-1部分:柔软同轴电缆组件分规范
10.
Radio frequency and coaxial cable assemblies--Part 3: Sectional specification for semi-flexible coaxial cable assemblies
GB/T16531-1996射频同轴电缆组件第3部分半柔软同轴电缆组件分规范
11.
Radio frequency and coaxial cable assemblies--Part 4: Sectional specification for semi-rigid coaxial cable assemblies
GB/T15867-1995射频同轴电缆组件第4部分:半硬同轴电缆组件分规范
12.
Welds repair of the bush of water flowing diversion bearing of the hydro-generator unit
水轮发电机组水导轴承轴瓦的焊接修复
13.
Research on Analysis of Shaft Bending Accident and Straightening Method for Turbo-Generator;
汽轮发电机组弯轴事故分析及直轴方法研究
14.
Transformation of Axis Seal and Oil Files of N 25-35-1 Gas Turbine;
N25-35-1型汽轮机组高低压轴封轴承油档改造
15.
The Analyses and Disposals of Abrasion of 600MW Unit's Axle Neck and Bearing
600MW机组轴颈和轴瓦损伤事故的分析及处理
16.
Precise determination of windings axes angle and model stiffness coefficients for bearingless motors
无轴承电机绕组轴线及控制系统刚度系数测定
17.
Main Engine Vibration Research of Supercritical 600MW Unit
超临界600MW机组主机轴系振动研究
18.
It consists of a pair of concentric cylinder.
它由一对同轴的圆筒组成。