1.
The Problem Happened in the Actual Use for the Tension Leveller of PL-TCM and Its Analysis;
酸轧机组拉矫机在实际使用中出现的问题及原因分析
2.
DESIGN AND ASSEMBLE PICKLING-ROLLING MILL SET WITH OLD EQUIPMENTS
利用旧设备拼装设计酸洗-轧机联合机组
3.
The Application of Totally Integrated Automation Solution in WISCO PLTCM No.2
全集成自动化解决方案在武钢二冷轧酸洗冷轧联合机组的应用
4.
Shallow Analysis on Design Plan of AISC No.2 Pickling-cold Rolling Combined Train
鞍钢2号酸洗-冷轧联合机组设计方案浅析
5.
Improvement of Notching Position for Side Notching in Pickling-Tandem Cold Mill Line
酸洗-冷轧机组中侧冲剪冲切位置的改进
6.
Brief Introduction of the Automation System of the Continuous Pickling & Tandem Cold Mill of Baotou Steel
包钢酸洗冷连轧机组自动化控制系统简介
7.
The Calculation of Capacity and Relevant Parameters of Pickling Part of the PL-TCM
酸洗—轧机联合机组酸洗线产量及相关参数的计算
8.
straightaway stands
串列式盘条轧机机组
9.
Comprehensive Evaluation of Strength and Stiffness about Rolling Mill Main Drive System of Mandrel Mill Group;
连轧管机组轧机系统强度的综合评价
10.
AUTOMATION OF A LINKED PICKLING AND TANDEM MILL AT BETHLEHEM STEEL, MD/USA
伯利恒钢铁公司酸洗冷轧联合机组的自动化系统
11.
Experiment-rolling Pipeline Steel X60 in 2300 mm Hot-rolling Line of Benxi Iron & Steel(Group) Co.,Ltd.
本钢2300mm热轧机组试轧X60管线钢
12.
Application Practice of the Hot Rolling Lubrication in Tangshan Jianlong 800mm Finishing Mill
800mm精轧机组热轧润滑工艺应用实践
13.
Introduction to φ258 PQF continuous pipe rolling mill newly built at Tianjin Pipe (Group) Corp.
天钢φ258PQF连轧管机组介绍
14.
The Discription of Level 2 Process System in Tandem-Pickling Production Line
酸轧联机酸洗二级过程控制系统概述
15.
Discussion on pass system of roughing mills of continuous bar or wire-rod mill
连续棒线材轧机粗轧机组孔型系统的探讨
16.
Vibration of Finishing Stands in Hot Strip Mill and Suppression Measure
热轧宽带钢精轧机组机架振动分析及抑制措施
17.
Analysis of Stiffness Measurement of Full-floating Mandrel Mill
全浮动芯棒连轧管机组的轧机刚度实测分析
18.
Based on the features of rough mill, two-lever interative algorithm is used to calculate the pass schedule of rough rolling.
根据粗轧机组自身的轧制特点,采用内外两层循环迭代的算法来分配粗轧机组的轧制规程。