1.
Study on Strengthening Technology of the Bearing Enclose Hot Die Protruding Mould
轴承内外圈热冲模凸模强化技术的研究
2.
die ,stamping (excl. relief printing dies)
冲模（不包括凸纹印花模）
3.
Crack Analysis in Heat Treatment of Cr12MoV Convex Mold;
Cr12MoV凸模热处理裂纹分析
4.
Improvement on heat treatment process of hot forging die for diesel camshaft
柴油机凸轮轴热锻模热处理工艺改进
5.
The Analysis and Defense Measure of Thin Punch Destruction
冲小孔凸模破坏形式分析及预防措施
6.
The Effect of Virtual Punch Velocity to the Simulation Result of Sheet Metal Forming
虚拟凸模速度对冲压仿真结果的影响
7.
The Lifetime Estimation of Fine-blanking Male-die Based on FEM Analysis;
基于有限元分析的精冲凸模寿命估算
8.
A Method for Monitoring Male Die Based on PVDF Piezoelectric-film;
基于PVDF压电薄膜的冲压模具凸模监测方法
9.
die ,for relief printing for stamping
凸版印模感压凸印模
10.
Processing of Radiator of Conical Mould of Picture Tube
探索彩色玻壳锥凸模模具散热槽电极的加工
11.
Failire Analysis and Enhance the Life Way for Cold Stamping Punch
O12Al冷冲凸模失效分析与提高寿命的途径
12.
Design of Polishing Fixture for the Piercing Punch by TD Vanadizing Treatment
冲孔凸模TD渗钒处理前后抛光工装结构设计
13.
Both the structure of die without punch guidance and protecting jacket are analyzed, and opinions that intensity of blanking small punch should be verified are concluded.
对无凸模导向和保护套的模具结构进行分析,提出冲裁小凸模强度核算应考虑的问题。
14.
Calculation of Heat Balance during Mold Filling for Hollow Camshaft in EPC
消失模铸造空心凸轮轴充型过程中热平衡计算
15.
The size accuracy of punching workpiece mainly depends on the cutting edge sizes, tolerances of convex die and concave die.
冲裁件的尺寸精度取决于凸、模的刃口尺寸及公差。
16.
the self-lock performance and effect of SPR are good when the height of die and boss is higher;
当凹模凸台较高时,自冲铆接的自锁性能和效果较好;
17.
Simulation of Stamping for Car-muffler Heat Insulation-cover;
轿车消声器隔热罩冲压成形模拟分析
18.
Heat Treatment Technics Experiment for Punching & Stamping Die of 65Nb Plate
65Nb钢链板冲裁模具热加工工艺试验