1.
Inspection machining dimension of propeller shaft( intermediate shaft or counter shaft).
螺旋桨轴（间轴）加工尺寸检查。
2.
Research and Implementation on Dimension Error Prediction and Compensation System for Boring;
镗孔加工尺寸误差预测与补偿系统的研究与实践
3.
We also can supply the products with customers' wishs and needs.
注：除上述规格尺寸外，也可按用户需要尺寸加工。
4.
NOTICE: The dimensions shown on the attached dwgs for ball are the finished (after final machining) dimensions; your rough machined forging must guarantee these final dimensions.
注：附件球体图纸上的尺寸为机加工后的最终尺寸，你们的粗加工锻件必须保证这些最终尺寸。
5.
Roughing end mill with flatted parallel shank types and dimensions
削平型直柄粗加工立铣刀型式与尺寸
6.
Roughing end mill with morse taper shank types and dimensions
莫氏锥柄粗加工立铣刀型式与尺寸
7.
Size Reduction and NC Simulation of PDC Bit
PDC钻头的尺寸还原与数控加工仿真
8.
The Coordinate Dimension s Calculation During the Machining of Holes in Boxes;
箱体孔系加工工序中坐标尺寸的计算分析
9.
They can be obtained in all the industrial sizes and their metric equivalents.
各种工业尺寸或公制尺寸的胸架都有。
10.
The Affection of Cutting Parameters on the Burr in Precision Machining
精密加工中切削参数对毛刺尺寸的影响
11.
Influence of Electrode Size on EDM Characteristics of Insulating Ceramics
电极尺寸对绝缘性陶瓷电火花加工特性的影响
12.
The Coordinate Dimensions Calculation and Analysis of Disc Type Component NC Machining
圆盘形零件数控加工的坐标尺寸计算及分析
13.
The NC Processing of Small Brand Based on the Picture;
小尺寸商标牌从图片到数控加工的实现
14.
Study on Tolerance Dimension Excursion Control During Machining;
关于加工中公差尺寸偏移控制的研究与探讨
15.
Control Method of Dimension Tolerance in Automatic Programming and Machining
尺寸公差在自动编程及加工中的控制方法
16.
the rate of increase in size per unit time.
单位时间内尺寸增加率。
17.
Use to add an angular dimension with dimension arrows that point inward.
用于添加指向内部的尺寸箭头的角度尺寸。
18.
Die forgings of aluminium and aluminium alloy--Dimensional tolerance and machining allowance
GB/T8545-1987铝及铝合金模锻件的尺寸偏差及加工余量