1.
The Research on Laser Assisted Cutting of Alumina Ceramics;
激光加热辅助切削Al_2O_3工程陶瓷材料的研究
2.
Theory and Experimental Investigation on Laser Hot-Assisted Machining Al_2O_3 Engineering Ceramics;
激光加热辅助切削Al_2O_3工程陶瓷理论与试验研究
3.
Technical Research on Laser Heat Assisted Turning Silicon Nitride
Si_3N_4陶瓷的激光加热辅助车削技术研究
4.
Detection and Characteristics of Heating Resistance of Cutting Zone in Electric Hot Machining
导电加热切削中切削区加热电阻的检测及特性
5.
Model of Heating Resistance of Shear Zone in Electric Hot Machining and Its Experiment Analysis
导电加热切削切削区加热电阻模型及试验分析
6.
The CAD of the spiral reamer anti-cutting distorts
螺旋绞刀抗切削变形计算机辅助设计
7.
Analysis of Influences of Cutting Parameters on Cutting Heat During Machining Casting Aluminium Alloy
加工铸铝合金时切削用量对切削热的影响分析
8.
Coupled Thermo-Mechanical Modelling and Experimental Research for Cutting Process;
切削加工热力耦合建模及其试验研究
9.
Research on Computer-Aided Design System of Low- Pressure Heater
低压加热器计算机辅助设计系统研究
10.
Experience-based Computer-Aided Cutting Parameters Selection Models and System;
基于经验的计算机辅助切削用量计算模型及系统
11.
A Study on Tennis Forehand and Backhand Chop "Racket Pole-Fore Arm Angle" and Design of Periphery Control Device for Teaching;
网球正、反手切削球“拍臂角”讨论及其教学辅助控制装置设计研究
12.
Experimental Study of Femtosecond Laser-Assisted Deep Lamellar Cut in Rabbit Corneas
飞秒激光辅助的兔眼角膜深板层切削的实验研究
13.
A is suitable for turning, milling, boring and grinding of hard metal such as heat resistant steel, high nickel steel and stainless steel.
A 极压切削液适合耐热钢、镍钢和不锈钢等高硬度材料的车削、削、孔、削等加工。
14.
Investigation and Simulation of Ultrasonic Vibration Assisted Electrical Discharge Milling in Gas;
基于气体介质的超声振动辅助放电铣削加工技术仿真研究
15.
Design and Application on Control System for Technology of Ultrasonic Vibration Aided Electrical Discharge Grinding Process
超声振动辅助磨削—脉冲放电复合加工控制系统设计及应用
16.
Thermal Performance Study on a Solar Energy Water Heating System in Conjunction with Air-source Heat Pump
空气源热泵辅助加热太阳能热水系统热性能研究
17.
Application of Counter-tangential Auxiliary Air on Reheater Retrofit of a 1175 t/h Boiler Against Heat Deviation
辅助风反切方式在1175t/h锅炉再热器热偏差改造中的应用
18.
Cutting Force Modeling in Turning Based on Cutting Parameters in Face Cutting;
基于切削参数的端面加工切削力模型