1.
The internal surface of cylinder is honed and processed so that the fricition coefficient is low and the service life is long.
气缸内表面经精细珩磨加工，摩擦系数低，使用寿命长。
2.
Laser Texturing Technology of Engine Cylinder Sleeve Internal Surface
发动机气缸套内表面激光造型加工技术
3.
The Bore is the diameter of the cylinder. The stroke is the distance the piston travels from BDC (Bottom dead center) to TDC(top dead center). The Bore is always mentioned first.
内径指的是气缸的直径;行程是活塞从下止点运行到上止点的距离。表述时,内径总是写在前面。
4.
Study on the technology of laser honing applied in machining the cylinder bore of engine
发动机气缸孔表面的激光珩磨技术研究
5.
Study of surface strengthening technology and wear test of diesel engine cylinder liner
柴油机气缸套表面强化工艺及磨损试验的研究
6.
Tribology Design for Bore Surface Topography of Combustion Engine
内燃机缸套表面形貌摩擦学设计的探讨
7.
Therefore, when the piston is pushed up in the cylinder, the air in the cylinder is trapped above the piston and compressed.
因此，当活塞在气缸里被推动向上时，气缸内的气体便被集聚在活塞上面并被压缩。
8.
The internal surface processing of hydraulic cylinder requires high accuracy of size, shape, and good deformed surface finish.
液压缸内表面要求较高的尺寸精度、状精度以及适宜的表面粗糙度。
9.
Valve Tappet Adjustment For Three And Five--Cylinder Engines
三缸与五缸内燃机气门间隙调整方法
10.
cylinder wall surface temperature transducer
汽缸壁表面温度发送器
11.
There are certain limits to which Cylinders may wear tapered or out of round before they require refinishing.
气缸磨损形成锥度或不圆,在达到一定的限度前,不必整修表面。
12.
Research on Detection Methods of Abrasion on the Surface of Cylinder Liner Based on Image Processing Technology;
基于图像处理技术的气缸套表面磨损检测方法研究
13.
The Application of Microarc Oxidation to Wear Resistant Processing of Inner Surafce on Steam Cylinder;
微弧氧化技术在铝制缸体内表面耐磨处理中的应用
14.
forces increased oxygen into the cylinders of an internal-combustion engine.
增强的压力把氧气压入内燃机的汽缸。
15.
Numerical Analysis of the In-Cylinder Flow in a Diesel Engine;
柴油机缸内气流运动规律的数值研究
16.
Research of In-Cylinder Dynamic Flow for WD615 Diesel Engine
WD615柴油机气缸内动态流场研究
17.
Research on In-cylinder Flow of Diesel Engine with CATIA
基于CATIA的柴油机缸内气体流动研究
18.
The cylinder head fastens to the top of the block, just as a roof fits over a house.
气缸盖固定在气缸体的顶上，正像屋顶套在一所房子上面一样。