1.
Research on Calculating Method of Response of Labyrinth Gas Seals with Damping Sleeve
带阻尼套筒的迷宫气封结构响应求解方法研究
2.
The Seal Structure Improvement of Multi-Seal Fuel Gas Separates
多密封燃气隔断闸阀密封结构的改进
3.
Amelioration of hermitical structure of balanced gas water heater;
平衡式燃气热水器密封性结构的改进方法
4.
Design of Seal Structure in Compressor for Air Source Heat Pump Heat Unit
空气源热泵热水机组压缩机密封结构设计
5.
"The resilient wedge design offers bubble-tight seating, but is limited to 160 f water service."
弹性楔板结构具有无气泡阀座密封功能,但是水温最高不能超过71℃。
6.
Study on the Safety Assessment and Structure Strength of Triple Valve Plugging-seal-off Components Used in Shan-jing Gas Pipeline;
陕京输气管线工程中三通封堵结构强度及安全性评定研究
7.
Design of Sealing Structure for Air Source Compressor Based on APDL Language
基于APDL语言的空气源热泵热水机组压缩机密封结构设计
8.
The steel structure of the entry seal chamber.
进口密封室钢结构;
9.
sealed construction
密封式结构 -继电器
10.
a closed sac that develops abnormally in some body structure.
身体结构中异常地生长封闭结构。
11.
Technology for End-coating Chip Resistors and the Structure and Principle of the End-coating Machine
片式电阻器封端工艺及封端机的结构原理
12.
Seal Structure and Technique of Broad Band High Power Rectangular Ceramic Hermetic Windows
宽带高功率矩形陶瓷密封窗封接结构及工艺
13.
The Edgy Machine that Takes Assistance Sealing Structure;
带有端面辅助密封作用的刀口机械密封结构
14.
The Study of Dynamic Seal Structure and Seal Force of Principal Axis with Inside Spray Fluid
内喷流体的动密封主轴结构和密封力研究
15.
The defects of the former top structure of the bricks of a heavy oil aerification furnace were analyzed, a new whole hanging top was proposed for application and the result was good.
分析了重油气化炉原炉口结构的不足,提出采用新型整体吊挂式封头,实践证明是成功的。
16.
As the climate active fa?ade is completely closed there is normally no possibility for natural ventilation and smoke exhaust (if necessary).
由于通常主动式气候调节幕墙是全封闭的结构，所以不能提供自然通风和排烟（如果必要的话）。
17.
A sealed transverse discharge device for getting homogeneous glow discharge excited with a DC power supply
一种可获得均匀辉光放电的封离式直流横向激励气体放电结构的研究
18.
Structure: Adopting to polyester film as dielectric, iuductrive construction, epoxy resin as dip material.
结构:聚酯膜作介质,有感结构,环氧树脂包封。