1.
outlet triangle
喷嘴出口速度三角图
2.
The Humidity Effect on the Discharge Coefficient of Sonic Nozzles
湿度对音速喷嘴流出系数影响的研究
3.
An outlet, such as a nozzle, used for emitting such a stream.
喷嘴用于施放流体的出口，如喷嘴
4.
Fully accelerating abrasive particle velocity to near water-jet velocity is main aid of nozzle design.
喷嘴设计的主要任务就是要使从喷嘴喷出的磨料粒子得到充分加速,以便接近水射流的速度.
5.
Estimation Method of Nozzle Exit Speed for Torpedo Turbine Engine
涡轮发动机喷管出口速度的估计方法
6.
Research about Nozzle Discharge Speed Distribution for Meltblown Model
熔喷模头喷嘴孔流场速度分布的研究
7.
outlet nozzle for pulse-jet engines
出口喷嘴,用于脉动式喷气发动机
8.
Influences of Impingement Distance and Impingement Angles on Wall-Wetted Fuel Film
喷嘴距离和喷嘴角度对油膜附壁的影响
9.
An aperture through which matter is discharged.
输出口，喷嘴物体被释放出的开口
10.
The Research on the System of Testing the Angle of the Sealed Inclined Plane of Oil Nozzle Base on Multipage Image Comparison;
多页图像比对测量喷油嘴密封座面角度系统研究
11.
At higher speeds, a larger amount of fuel tends to be discharged from the main nozzle.
在较高转速时。主喷嘴会喷出大量的燃油。
12.
Effect of velocity ratio on combustion process gas-gas injector
速度比对气-气喷嘴燃烧性能的影响
13.
Passing through the nozzle at the highest speed, Impulse turbine steam directs against a row of blades which assembled in the axles of Impulse turbine with radiation shape.
当蒸汽以最高速度从喷嘴里喷出时，便冲击一列呈辐射状安装在涡轮机主轴上的动叶片。
14.
A high-velocity fluid stream forced under pressure out of a small-diameter opening or nozzle.
喷射流体在压力迫使下从小喷嘴或小孔中喷出的高速流体
15.
Influence of Entrance Shrinking Angle on Nozzle Wear in Swirling Abrasive Water Jet
入口收缩角对旋转磨料射流喷嘴磨损的影响
16.
Results showed that the temperature, temperature gradient and thermal stress at the exit surfaces of the CWS ceramic nozzle were higher than that of other part of the nozzle.
结果表明：在陶瓷水煤浆喷嘴的出口端面存在较大的温度、温度梯度和热应力。
17.
Flames jetted out (of the nozzles).
火焰（从喷嘴中）喷出来了.
18.
Numerical Analysis on Cross Flows Velocity Affected to Swirl Jet Atomization
横向流速度对旋流式喷嘴雾化影响的数值分析