1.
Recommended flywheel bolt torques are:
飞轮螺栓的推荐扭力为：
2.
Install a new cam bolt, cam and new nut in the axlRe-align the reference marks.
在轴上安装新凸轮螺栓，凸轮和 新螺帽。重新校准参考标记。
3.
Loosen the coolant pump pulley bolts while the belt is still tight.
在皮带仍然紧时，放松冷却水泵滑轮螺栓。
4.
Remove the upper flywheel and converter housing bolts and loosen the bottom bolts.
拆卸上部飞轮及转换器外壳螺栓，拧松底部螺栓。
5.
These nuts and bolts hold the wheels on.
这些螺帽和螺栓把轮子固定住了.
6.
These bolts and nuts hold the wheels on.
这些螺栓和螺帽把轮子固定下为。
7.
Reinstall handwheel and secure with retaining bolt.
重新安装手轮，用固定螺栓加固。
8.
Contact analysis of MW wind turbine hub and bearing bolt connection
风力机轮毂和轴承螺栓联接接触分析
9.
Analysis of bolt fracture failure for high-pressure main stop valve of turbine
汽轮机高压主汽门螺栓断裂失效分析
10.
Inspect crankshaft, flexplate/flywheel and bolts for damagTighten to correct torque
检查曲轴、活动板/飞轮和螺栓是否松动。拧紧螺栓以校正扭力。
11.
Remove the upper engine flywheel/converter housing bolts and loosen the bottom bolts.
卸去上端引擎飞轮/转换器壳体螺栓，并拧松底部螺栓。
12.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
13.
Position flywheel and O-ring on crankshaft and align bolt holes.
安装飞轮和O形环在曲轴上并对齐螺栓孔。
14.
Remove the remaining converter (or engine flywheel) housing bolts.
卸去其他的转换器壳体（或引擎飞轮）螺栓。
15.
Remove the flywheel or converter drive platDiscard the old bolts.
拆卸飞轮和转换器驱动圆盘。扔掉旧的螺栓。
16.
Remove the universal joint strap bolts at the pinion shaft yoke.
在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
17.
Study on the Fracture of the Anchor Bolt and the Vibration of the Ship s Main Engine;
某轮柴油主机振动与地脚螺栓断裂研究
18.
Bend and Craze Analysis of Hoisting Bolt of Aerogenerator Impeller
风力发电机组叶轮吊装螺栓弯曲开裂分析