1.
Casting technology and optimization of trailer big end based on ProCAST
基于ProCAST的拖车连杆头铸造工艺优化研究
2.
A beam that connects the piston rod to the connecting rod of a reciprocating engine.
十字头连接活塞杆和往复式发动机连杆的横杆
3.
Powder Metallurgy Forging and Cleavaging Technics for Conn-Rod
连杆粉末冶金锻造与连杆大头劈裂技术
4.
a fastener with a tapered threaded shank and a slotted head.
由带螺纹的连杆和槽头组成的扣件。
5.
The crank end of the connecting rod is sometimes called the rod "big end".
连杆的曲轴有时称为“大头”。
6.
Optimize and Design for the Four-Link Structure of the Die Bonder and Motion Simulation Based on the CosmosMotion
基于CosmosMotion的焊头四连杆机构优化设计
7.
A lower, rearward surface, as of the head of a golf club where it joins the shaft.
尾端部位高尔夫球棍头上和杆相连的弯头
8.
Analysis of Small End Bushing and Crosshead Pin Failure of Fresh Hydrogen Compressor Connecting Rod in Hydrocracking Unit
加氢裂化新氢压缩机连杆小头衬套与十字头销烧损原因分析
9.
A rod or lever transmitting motion in a machine.
连杆机器中传递运动的连杆或杠杆
10.
Disconnect stabilizer bar links at the axle.
断开车轴上稳定杆连杆。
11.
a round-headed bolt for timber; threaded along part of the shank; inserted into holes already drilled.
加工木料用的圆头螺栓；部分连杆有螺纹；可以插入事先钻出的孔中。
12.
The main bearing journals fit into the cylinder block and the big end journals align with the connecting rods.
主要轴承曲颈安装在气缸体和与连杆大头末端匹配的曲颈上。
13.
For this big-end bearing, steel-backed lead or tin shell bearings are used.
对连杆大头轴承来说，使用的是铅的钢背或锡的轴瓦式轴承。
14.
Analysis on ablation failure of connecting rod and crosshead in large 6HF/3 type reciprocating compressor
6HF/3大型往复压缩机连杆与十字头销烧蚀故障分析
15.
"The cylinder of an internal-combustion engine is closed at one end by a plate called the head and open at the other end to permit free oscillation of the connecting rod, which joins the piston to the crankshaft."
内燃机的汽缸在一端用盖封住,叫做头,另一端敞开,使连接活塞和曲轴的连杆能自由摆动。
16.
Variation laws of connecting rod curves for five bar and similar four bar mechanism
类四杆五杆机构连杆曲线的变化规律
17.
Install connecting rod bolt protectors on rod bolts.
在连杆螺栓上安装连杆螺栓保护件。
18.
The rod-bearing cap attaches the connecting rod to the crankpin.
连杆轴瓦盖将连杆安装到曲轴销上。