1.
POSITION SENSOR PRINCIPLE AND AXIAL EXCITING COIL EMF OF AXIAL AND RACIAL AIR GAP HYBRID MAGNET CIRCUIT MULTI-COUPLING MOTOR
轴径向气隙混合磁路多边耦合电机轴向励磁绕组的反电势及其位置传感器机理
2.
Pressure Calculation of Powder Gas in Bush Radial Clearance
衬套径向间隙部位火药气体压力计算
3.
Gear-to-Body Clearance (Radial)
齿轮至缸体间隙(径向)
4.
" Spherical plain radial bearings, joint type-Redial internal clearance"
GB/T12278-1990向心关节轴承径向游隙
5.
Analysis of the Feed Structure of Millimeter Wave Radial Line Slot Antennas;
毫米波径向线缝隙天线馈源结构分析
6.
How many radial( axial) clearnance are there in this bush( journal bearing, thrust bearing)?
这个轴套（颈轴承、推轴承）径向（向）隙是多少？
7.
Selection and fit of compound clearance of angular contact ball bearing with double inner rings
双内圈角接触球轴承轴向和径向游隙的选配
8.
Do not reduce the size of the drain line from the air gap fitting.
不要缩小从气隙接出的拍下管道的口径。
9.
Effects of Porosity on Gas Permeability and Maximum Pore Size of Fiber Felts
孔隙度对纤维毡透气性能和最大孔径的影响
10.
Test method for determination of radial interstitial oxygen variation in silicon
GB/T14144-1993硅晶体中间隙氧含量径向变化测量方法
11.
Research on a Capsule Micro-Robot with Radial Clearance Self-Compensation Function;
径向间隙自补偿胶囊微型机器人的研究
12.
Radial Distribution of Voidage in a Fixed Bed Reactor with Lower Diameter Ratio of Bed to Particle
床层与颗粒直径比小的固定床反应器径向空隙率分布
13.
The inner layer( S3) of secondary wall is absent, the outer( S1+ S2) is wider than normal and the middle layer shows many radial discontinuities.
从径向切面或切向面看，在管胞次生壁上常具有明显的螺纹裂隙。
14.
399 How many radial (axial ) clearnance are there in this bush (journal bearing , thrust bearing) ?
这个轴套（轴颈轴承、止推轴承）的径向（轴向）间隙是多少？
15.
Simulation of Acoustic Field in a Fluid-Filled Borehole Surrounded by a Radially Multilayered Porous Formation
径向分层孔隙介质包围的流体井孔中声场的模拟
16.
Investigation of the Radial Clearance Leakage in Rolling Piston Compressors Based on CFD
基于计算流体力学的滚动活塞压缩机径向间隙泄漏研究(英文)
17.
The Optimal Design of Radial Gap of External Gear Rotary Pump with the Least Total Power Loss
总功率损失最小为设计目标的外啮合齿轮泵最优径向间隙
18.
Influence of inner ring double raceways centre distance of self-aligning roller bearing on radial clearance
调心滚子轴承内圈两滚道中心距对径向游隙的影响