1.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
2.
Oil may be forced out through the timing cover and rear-main bearing oil seals.
机油会从正时齿轮盖和后主轴承油封处压出。
3.
Aligning main engine's crank shaft and intermediate shaft after launching.
下水后主机曲轴和中间轴连接后校中。
4.
Measuring deflection of crank shaft of M.E. before starting up(after sea trial).
主机动车前（航行试验后）曲轴甩档测量。
5.
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床
6.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
7.
"Semifinished main bearings require finishing and fitting after installation, so that the crankshaft must be taken out."
半精加工的主轴承安装后需要修整和调配,这样曲轴就必须拆下。
8.
"Rotary motion of the transmission main shaft carries through the propeller shaft to the differential, causing the rear wheels to rotate."
变速器主轴的旋转运动通过传动轴传递到差速器上,使后车轮转动。
9.
The rear axle is stationary, and is bolted rigidly to the main frame.
后轴是固定的，用螺栓刚性固定在主机架上。
10.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
11.
Crankshaft main journal out of round or worn
曲轴主轴颈不圆或磨损
12.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
13.
Crankshaft and main bearings service
曲轴和主轴承的维修
14.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
15.
They permit the friction disk to slide Back and forth along the shaft But force the disk and the shaft to rotate together.
可以使摩擦盘沿着主轴向后或向前滑动,又可使圆盘和主轴同时转动。
16.
Secondly, according to the distinctive demand of bonnet tool polishing, the motorized-spindle system is designed and manufactured.
然后,根据气囊式抛光对电主轴的独特要求,设计并制造了电主轴系统。
17.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
18.
Wheel base( front-mid/mid-rear)
轴距(前-中/中-后)