1.
Experiment on Welded Flange Plate (WFP) Reinforced Conneciion
钢结构焊接翼缘板加强式梁柱刚性连接的试验研究
2.
These include gusset plates welded to the flange.
这些包括焊接到翼缘上的节点板。
3.
The second crack is a crack originating at the groove weld toe of the column flange-girder flange connection.
第二种是产生于立柱翼缘与主梁翼缘连接处的坡口焊缝焊趾处的裂纹。
4.
Cracks have been found in the flange and web splices at groove welds in at least four bridges.
至少在四座桥梁的翼缘板和腹板拼接坡口焊缝中发现了裂纹。
5.
spiral welded-on wing stabilizer
焊接螺旋翼片式稳定器
6.
There are two methods for welding radial stiffeners to bias-rail box girder: welded all around and open at tensile flange.
起重机偏轨箱形梁横向加强板有加强板四周均焊和在受拉翼缘处空开2种焊接方式。
7.
a straight line connecting the leading and trailing edges of an airfoil.
连接机翼的前缘与后缘的直线.
8.
Small rectangular backup bars were used to fabricate the web-bottom flange connection.
在腹板与下翼缘的施焊中使用小矩形挡板。
9.
a hinge mortised flush into the edge of the door and jamb.
直接被焊接到门和柱的边缘的铰链。
10.
These cracks occurred at either the beam flange or in the column flange depending on the reentrant corner weld angle.
这些裂纹视凹形焊角的不同，或者出现在横梁翼缘上，或者出现在立柱翼缘上。
11.
For instance, you should make sure that the insulations between the soldering tweezers and welding cable are ok and the earthing point and each termipoint of soldering machine are in good condition.
如焊钳和焊接电缆的绝缘是否有损坏的地方，焊机的外壳接地和焊机的各接线点接触是否良好。
12.
Remove the all of urethane from all pinchweld flanges.
由夹紧焊接凸缘去除所有尿烷。
13.
The Research on Static Behavior of Top and Seat Angle Semi-rigid Connections;
上下翼缘角钢半刚性连接的静力性能研究
14.
"When joint is filled, a continuous rim of brazing alloy will be visible."
连接处被充满后,就会看到焊接合金的边缘。
15.
Finite Element Simulation of Welding Residual Stress for the Integrate Insulation Adapter
整体绝缘接头焊接残余应力有限元模拟
16.
Inspect and repair the windshield opening and pinchweld flanges.
检查并修理挡风玻璃开口与夹紧焊接凸缘。
17.
Analysis and countermeasures of overproof of the edge deviation of welding line in circular seam welding of boiler drum
锅筒环缝对接焊缝边缘偏差超标分析及对策
18.
Insulation Structure for a High Current Diode by Ceramic-metal Welding
基于陶瓷-金属焊接的强流二极管绝缘结构设计