1.
The Influence of the Numbers of Movable and Stationary Flat on Nep and Impurity
活动盖板和固定盖板根数对棉结杂质的影响
2.
Very close setting of front plate or non-parallel setting.
前固定盖板针布隔距太紧或与锡林针布不平行。
3.
Screw, crank cover
曲柄轴盖子固定螺丝
4.
hold-open catch
(舱盖打开时的)固定卡销
5.
Seat Cushion Cover Retaining Clip Removal
座椅垫盖固定螺钉拆卸
6.
Install the serrated retainers at the ends of the cover.
在盖的末端安装蛇型固定装置。
7.
crowfoot holddown
将盖子固定在搭板上的叉子
8.
Roll the seatback cover downward and engage the hook and loop fastener.
向下旋转座椅背盖，安装钩环固定器。
9.
Experimental Research and Theoretical Analysis for the Honeycombed-core Floor with Four Edges Clamped;
四边固定蜂巢芯楼盖试验及理论研究
10.
deck securing fitting
甲板绑扎固定用具; 甲板或舱盖上固定集装箱的装置
11.
Remove the four screws that secure the ACM mounting bracket to the floor pan transmission tunnel.
拆去固定ACM固定支架到底板变速器-传动轴盖板的四个螺丝。
12.
Loosen the screw holding the junction box cover to the top of the water heater. Set the cover aside.
卸下热水器顶部接线盒盖上的固定螺丝。把盖子放在旁边。
13.
The valve cover shall be held in place through the use of a single grooved style two-bolt coupling.
阀盖应该通过单个沟槽状双螺栓联结器固定住。
14.
A threaded-on, pressure/vent cap mounted to the coolant tank
安装在冷却剂箱上的螺纹固定的压力/排气盖
15.
Bolted on, top entry single access cover for ease of maintenance.
螺栓固定，顶部进入的唯一检修盖，便以维护。
16.
Position the underhood lamp on the hood inner panel.
将引擎盖未闭合灯固定于引擎罩内板上。
17.
Sweat Solder adapter with Cover Tube and Cast Set Screw Wall Flange
焊接焊料适配器含盖管和铸造固定螺栓墙法兰
18.
Install push-in fasteners holding trunk lid slam bumpers to top of fascia.
安装将行李厢盖沿保险杆紧固到面板顶部上的推进式固定件。