1.
Lightly lubricate pilot bearing with Mopar® high temperature bearing grease.
用Mopar®高温轴承黄油轻轻地润滑引导轴承。
2.
The Study on the Hybrid High-Temperature Superconducting Magnetic Bearing System;
高温超导混合磁悬浮轴承系统的研究
3.
Numerical Calculation and Experiment of High Temperature Superconducting Magnetic Bearings;
高温超导磁悬浮轴承数值计算与实验
4.
Study on Increasing Pre-finishing Temperature of GCr15 Bearing Steel Wire
提高GCr15轴承钢线材预精轧温度的研究
5.
The Study and Experiment on the Hybrid High-Temperature Superconducting Magnetic Bearing System～2;
高温超导混合磁悬浮轴承系统的研究与实验
6.
Research of Numerical Design and Precision Analysis System of Ball Bearing at Elevated Temperature;
高温球轴承数值化设计与精度分析系统的研究
7.
Helium Circulator Supported by AMB for HTR-10 Thermal Test
高温堆磁悬浮轴承备用氦风机热工实验研究
8.
Testing and Evaluation of Elevated Temperature Resistance of Greases for Rolling Bearings
滚动轴承润滑脂耐高温性能的试验及评价
9.
The Excessive Maintenance of Bearing and the Field Treatment of Dynamic Balance in High Temperature Fan
高温风机轴承过维修与动平衡的现场处理
10.
Analysis and Improvement on High Temperature of Motor Bearing
电动机轴承温度高原因分析及改进措施
11.
Research on the new high temperature superconducting magnetic bearings for flywheel energy storage device
飞轮储能器的新型高温超导悬浮轴承研究
12.
Parameterized Modeling and Research of Thermal Deformation of Rolling Bearing at Elevated Temperature
高温滚动轴承参数化建模及其热变形研究
13.
An appropriate amount of high-grade grease(bearing 130℃ and being waterproof) is prepacked in the bearings.
轴承已注入适量的高级润滑脂（能承受130℃的高温并具有防水性能）。
14.
Stability of Small-Sized Grooved Bearings-Spindle System in High-Speed Hard Disk Drive Considering Thermal Effect
高速硬盘微小型滑动轴承—主轴系统变温条件下的稳定性研究
15.
Causes and Solutions of Over-temperature of Bearing on the Motor of Turbine Fan
透平风机电机轴承温升过高原因分析及处理方法
16.
Thermo-hydrodynamic Analysis of Herringbone Grooved Journal Bearings
高速硬盘螺旋槽动压滑动轴承变温条件下的动力学特性
17.
Study on mixed magnetic suspension bearing system based on high-temperature superconductor and normal conductor
高温超导和常导的混合磁悬浮轴承系统机理研究
18.
The oil must have a sufficiently high viscosity at high operating temperatures to ensure the formation of a continuous film of oil between the bearing and shaft.
润滑油在较高的工作温度下必须具有足够高的粘度，以确保轴承和轴之间形成连续的油膜.