1.
conical rail bond pi
圆锥形钢轨导接线塞钉
2.
rail bond resistance tester
钢轨导接线电阻测试器
3.
Fracture Analysis of U75V Welding Rail during Installing Process
U75V焊接钢轨线路铺设时的断裂原因分析
4.
Selection of Body-form Co-efficient of Wind for Double Contact Lines of OCS in Urban Mass Transit
城轨交通接触网双导线风载体型系数的选用
5.
Dissimilar Welding of Bainitic Steel Crossing and U71MN Rail
贝氏体钢辙叉与U71Mn钢钢轨的焊接
6.
Method of Determining Ball Dimensions in Rolling Linear Motion Guide Way Support Pair Assembly
直线运动滚动导轨副装配中钢球尺寸的确定方法
7.
Calculation of Impedance of Rail Track for Ballastless Track Line;
无碴轨道线路钢轨阻抗参数计算方法
8.
Research on Design of the 40.5 m Steel Track Girder for Line 2 of Chongqing Light Rail
重庆轻轨2号线40.5m钢轨道梁设计研究
9.
Specification for construction and acceptance of wire pipelines with fastening connection steel conduit
套接紧定式钢导管电线管路施工及验收规程
10.
Flash butt welding of bainite steel crossing with U71Mn steel rail
贝氏体钢辙叉与U71Mn钢轨的焊接
11.
Clamping unit contains two crankshaft and is made of high-intensity steel. It uses straight-line rail which runs fast and easily.
采用高拉力钢制造的双曲轴锁模机构、移动部件采用直线导轨，具有高刚性、运行轻快等特点。
12.
The widening of gauge and the overturning of rail will effect the contact point and dynamic forces between wheel and rail.
轨距扩大和钢轨侧翻将影响到轮轨接触点位置和动力作用。
13.
Abstract: The widening of gauge and the overturning of rail will effect the contact point and dynamic forces between wheel and rail.
文摘:轨距扩大和钢轨侧翻将影响到轮轨接触点位置和动力作用。
14.
High strength joint bolts and nuts for rails
GB/T5098-1985钢轨用高强度接头螺栓、螺母
15.
Brief Talks of the Causes of Rail Joint Disease and Their Treatments
浅谈钢轨接头病害的成因和整治措施
16.
Surface Quenching Research on GCr15 Steel Linear Motion Guide
GCr15钢制导轨的表面淬火研究
17.
single rail crossing
只有行车钢轨的线路交叉
18.
two rail crossing
由两钢轨组合的线路交叉