1.
head contour measurer for hatters
封头外形测量仪,制帽工人用
2.
Computing programs of the height of the curved edge of the external surface of a standard ellipsoidal head.
标准椭圆形封头外表面曲边高度的计算程序
3.
BALL JOINT SEAL BOOT
球形接头密封防尘套
4.
The Effect of the Single Dimple Initial Geometry Defect on Critical Load of External Compression Spherical Dome
凹圈型初始几何缺陷对外压球形封头临界载荷的影响
5.
NUMERICAL SIMUL ATION OF THICK WALL HEAD WARM FORMED BY MOULDLESS SPINNING;
厚壁封头无胎温旋压成形的数值模拟
6.
Study on the Gate s Retractile Seal Engineering Research with High Water-pressure;
高水头弧形闸门伸缩式水封止水研究
7.
Numerical simulation and experimental research of lager thick-wall semi sphere head forming
大型厚壁半球形封头成形的模拟与试验研究
8.
Discussion on Shape Factor K and Factor K_1 of the Standard Elliptical Head
对标准椭圆形封头形状系数K和系数K_1的讨论
9.
Appearance quality for rotary shaft lip seals
GB/T15326-1994旋转轴唇形密封圈外观质量
10.
Specification of lead frames for small outline package
GB/T15878-1995小外形封装引线框架规范
11.
ellipsoidal head
椭球体的封头, 椭圆封头
12.
Limit load analysis on spherical head with pit located in the structural discontinuity area
球形封头上结构不连续处凹坑极限载荷分析
13.
Calculation of Gravity Centre and Section Trace Line Shape of Elliptical Head
椭圆封头的重心及剖切迹线形状的计算
14.
Experimental Research and Numerical Simulation of Elliptical Heads by Integral Hydro-bulging;
封头整体内压胀形实验研究及数值模拟
15.
Study and Test of Expansion Type Water Seals for High Water Head Tainter Gates
高水头弧形闸门伸缩式水封止水试验研究
16.
Design of cone-head & cone-hole pipeline cone sealing structure based on ANSYS
基于ANSYS的锥头-锥孔管路锥形密封结构分析
17.
Experiment Research of Zirconium Head Forming and It's Practice
锆制封头成形方法的试验研究及其实践
18.
Numerical simulation on dynamic response of the cylindrical explosion containment vessel with an elliptical cover
椭圆封头圆柱形爆炸容器动力响应的数值模拟