1.
EFFECT OF DUAL-PULSES ON Al-Mn ALLOY COATINGS ON IRON ELECTRODEPOSITED WITH A LOW TEMPERATURE MOLTEN SALT BATH
双脉冲镀对低温熔融盐镀Al-Mn合金层的影响
2.
Fast Reduction Ore at Low Temperature and Smelting Process
基于低温快速预还原的熔融还原炼铁流程
3.
Lead fuses at a low temperature.
铅在低温下就熔化。
4.
Preparation of LiMn_2O_4 by Low Temperature Molten-Combustion Method
低温熔盐燃烧法制备LiMn_2O_4
5.
Rapid growth of“ mother dendrites” in a given location of a melt at just below the liquidus temperature, that growth being the result of rapid heat extraction from the melt, or from recalescence.
在特定的熔点，以低于液相线的温度快速生成“母晶枝”，这是使熔融金属或复辉快速散热的结果。
6.
Study on Improving the Fusibility of Shenhua-coal-ash;
提高神华煤灰熔融温度和熔融性的研究
7.
The addition of a plasticizer may lower the melt viscosity, elastic modulus, and glass transition temperature (Tg) of a plastic.
同时,加入增塑剂,还可以降低塑料在熔融态时的粘度、弹性模数及玻璃转变温度(tg)。
8.
Metamorphic Dehydration and Partial Melting in Continental Subduction Zones: A Study of Low-T/UHP Metagranite in South Dabie
大陆俯冲带变质脱水与部分熔融：南大别低温/超高压变质花岗岩研究
9.
The melting sticking occurred when the melting point of materials is lower than the drying temperature.
物料熔点低于干燥温度时容易产生热熔性粘壁。
10.
Technology for melt crystallization-granulation with air cooling in lower prilling tower and its application
全熔融低塔风冷结晶造粒技术及应用
11.
treated by heating to a high temperature but below the melting or fusing point.
将之加热至高温但又低于熔点。
12.
Lead will fuse at a lower temperature than some other metals.
铅熔化的温度比别的金属低。
13.
Effect of ESR on Cryogenic Toughness of Austenitic Steel
电渣重熔对奥氏体钢低温韧性的影响
14.
Study on a New Process for Alkalline Smelting Bismuth Sulfide Concentrate at Low Temperature
硫化铋精矿低温碱性熔炼新工艺研究
15.
Investigation on nanosized fuse-promoting adhesives of super low temperature ceramics glaze
陶瓷超低温釉纳米助熔粘接剂的研究
16.
Preparation of Magnetic Alloy Film via Low Temperature Molten Salt Electrochemistry
低温熔盐电化学制备CoNiFe磁性合金膜
17.
The product is compatible with pad-dyeing hot melt process, high temperature-pressure dip-dyeing process and low temperature adsorbing and fixing dip-dyeing process.
本品对轧染热熔法、高温热熔法侵染、低温吸附固着法侵染都很适用。
18.
The molten glass flows through orifices and temperature resistant bushings at the base of each furnace.
熔融的玻璃液流过喷丝头以及熔炉底部的耐高温衬套,