1.
Optimization Study on the Pressure Position of Dynamic Soft Reduction for Continuously Cast High-level Pipeline Steel
高级别管线钢板坯动态轻压下最佳压下位置研究
2.
Study on Heat-transfer Model of Solidification and Prediction Model of Soft-reduction Position for Continuous Casting Slab;
板坯连铸凝固传热及压下位置预报模型的研究
3.
Robust Dynamic Output Feedback Synchronous Control for Both Sides of Pressing Down Position System for Cold Rolling Mill
冷带轧机两侧压下位置系统鲁棒动态输出反馈同步控制
4.
Note: Use a pressure gauge downstream to adjust and verify the pressure setting.
注：在下游位置采用压力表进行调节并核对压力设置结果。
5.
Illustrated below are some commonly accepted positions of the lever and weight.
下图是常见的、能够接受的操纵杆和压铁位置。
6.
Study on the arc tracking system of all-position pulsed TIG welding under high-pressure environment
高压环境下全位置脉冲TIG焊弧长跟踪系统研究
7.
hydraulic roll screwdown
液压式轧辊压下装置
8.
"If air compressor is reciprocating type, Check Valves shall be downstream of receiver tank."
如果空气压缩机是往复型,则止回阀应该位于接受槽的下游位置。
9.
(3) the dynamic pressure of tidal bore reaches maximum little below the original tidal level, and decreases with the increase of depth.
(3)涌潮动压力在低潮位偏下的位置达到最大值 ,然后逐渐减小。
10.
To place in a prone position.
使倒伏置于向下的位置
11.
centre position
中间位置，(液压泵的)正常位置
12.
CONNECT AN OIL PRESSURE GAUGE IN ITS PLACE.
在这个位置连接油压计。
13.
a secondary or inferior position or status.
第二位的或低下的位置。
14.
Computer control of hydraulic screw down system should have a function of rolling force closed circuit control and roll position closed circuit control.
电气控制系统中的液压压下计算机控制系统要实现轧制压力闭环控制和轧辊位置闭环控制
15.
Wide profile processing range due to convenient locating and clamping device setting.
压紧与定位装置上、下、调，可适用于各种规格、面的型材，通用性强。
16.
"After the engine starts and the ignition key is released, spring pressure returns it to the ON position."
发动机启动以后,点火钥匙回转,在弹簧的压力下,恢复到"开启"位置。
17.
Further tweak to make more early shots when under pressure or in good position.
在压力下和处于好位置时，球员会选择更早地射门。
18.
Design of Hydraulic Pressure Transmission System of the Repairing Checking Clamp of Plane
某型飞机主起落架放下位置锁检测夹具用液压传动系统的设计