1.
the Mathematical Model and Examination Validating of Cutter Force in Flying Cutter Machining;
飞刀加工切削力数学模型及试验验证
2.
Cutting Force Modeling in Turning Based on Cutting Parameters in Face Cutting;
基于切削参数的端面加工切削力模型
3.
A Dynamic Mathematical Model for the Cutting Force in Chip Segmentation
半不连续切屑形成过程切削力动态数学模型
4.
Continously,by the method of orthogonal design,in the certainconditions, the mathematic models for cutting force and temperature were esta-lished;
继而,采用正交设计试验方法,建立了某些切削条件下,切削力、切削温度的数学模型;
5.
Dynamic Modeling, Simulation and Optimization of High Speed Milling under Complicated Cutting Conditions;
复杂切削条件高速铣削加工动力学建模、仿真与切削参数优化研究
6.
Optimization in cutting factor based on the model of cutting force of the high speed NC gear milling machine tools
基于数控高速铣齿机切削力模型的切削用量优化
7.
The stability and cutting forces in high speed milling process can be forecasted with the model.
利用该模型，可对铣削过程的特征参数如稳定性、切削力等进行预测。
8.
Mechanical Model of Water Saturated Sand Cutting at Blade Large Cutting Angles
绞刀片大角度切削水饱和沙的力学模型
9.
Mathematic Model on Cutting Parameter Optimization for Unit Cutting Process
面向单元切削过程的切削参数优化模型
10.
PREDICTION OF THE CUTTING FORCE IN END MILLING OF DIFFICULT-TO-MACHINE MATERIAL POCKETS
难加工材料型腔圆角数控铣削的切削力预测
11.
4. Reasons and influencing factors of metal burr formation are discussed; mathematical model in cutting direction burr is set up;
4、探讨了金属切削毛刺的产生原因、影响因素，并建立了切削方向毛刺的数学模型；
12.
Numerical Simulation of Dynamic Characteristics on Cutting Temperature Field and Cutting Force in High-speed Hard Machining
高速硬态切削温度场和切削力动态变化的数值模拟
13.
Research on the Nonlinear Dynamics Analysis of Regenerative Tool Chatter
再生型切削颤振的非线性动力学分析
14.
Models of Cutting Temperature and Force of Ultra-high Strength Steel in CNC Lathe
超高强钢数控车削温度和车削力模型的建立
15.
Research on Grey Model of Chip Qualified Rate and Cutting Force of Typical Biomaterials;
典型生物质材料削片合格率灰色模型与切削力研究
16.
The Mathematical Model of Drilling Force and FEA of Gun-drill with Planar Flank;
平面型后刀面枪钻的钻削力数学模型及有限元分析
17.
A study on NC mathematical model of the internal and external three prism milling
三棱形内外圆磨削数控数学模型研究
18.
Study on New Drilling Force Model of Vibration Drilling and Vibration Drilling with Invariable Parameter and Variable Parameter;
振动钻削新钻削力模型及定、变参数振动钻削的研究