1.
Plastic Rate-Dependent Experiment and Constitutive Model for Dual Phase Steel 600
双相钢DP600塑性率相关效应试验及本构模型
2.
testing method for melt flow rate of thermoplastics
热塑性塑料熔体流动速率试验方法
3.
Test method for melt flow rate of thermoplastics
GB/T3682-1983热塑性塑料熔体流动速率试验方法
4.
Determination of shrinkage for injection moulding thermoplastics
GB/T15585-1995热塑性塑料注射成型收缩率的测定
5.
" Rubber, raw natural--Determination of plasticity retention index"
GB/T3517-1992天然生胶塑性保持率的测定
6.
Superplasticity of TA15 Titanium Alloy Induced by Strain Rate Cycling
TA15合金应变速率循环超塑性研究
7.
Thermoplastic pipes--Determination of resistance to external impact--True impact rate method
GB/T14152-1993热塑性塑料管材耐外冲击性能试验方法真实冲击率法
8.
Inter-relationship between viscosity and plasticity as viewed from dissipative rate function
从耗散率函数看黏性与塑性间的内在联系
9.
FATIGUE PROPERTIES OF LOW CARBON LOW SILICON TRIP STEEL
相变塑性钢的低周疲劳性能和裂纹扩展速率
10.
Preparation of Y-TZP/MgAl_2O_4 Ceramic Composite and Research on Its High-Strain-Rate Superplasticity;
Y-TZP/MgAl_2O_4复相陶瓷的制备及高应变率超塑性研究
11.
Study on High Strain Rate Compression Superplasticity of Commercial AZ31 Magnesium Alloy;
工业态AZ31镁合金高应变速率压缩超塑性研究
12.
Influence of Strain Rate on Grain Refinement by Plastic Deforming;
应变速率对强塑性变形晶粒细化的影响
13.
Elastic-Plasticity Analysis of Ⅰ/Ⅱ Mixed Mode Crack and Probability Caculation of Fracture Failure
Ⅰ-Ⅱ型裂纹的弹塑性分析及断裂失效概率计算
14.
Effect of Initial Water Content on Compression Behavior of Reconstituted Lianyungang Clays
初始含水率对重塑连云港黏土压缩特性的影响
15.
Plastic Deformation and Nanocrystallization of Metallic Materials at High Strain Rate
金属材料的高应变率塑性变形及纳米化
16.
Three-dimensional Non-linear Rate-dependent Numerical Analysis and Experimental Study of the Thermoplastic Composite AS4/PEEK;
热塑性复合材料AS4/PEEK非线性率相关三维数值分析与实验研究
17.
Improvement on the Severe Plastic Deformation Method and Investigation on the Mechanical Properties of Ultra-Fine Grained Aluminum;
强塑性变形方法的改进及超细晶纯铝应变速率敏感性研究
18.
The Study on the Experiment of the Dynamic Fracture Toughness of Rate-dependent and Elastic-plastic Materials;
应变率相关弹塑性材料动态断裂韧性的试验研究