1.
cam shaft displacement control for reversing engines
可倒转发动机的凸轮轴位移控制器
2.
Eddy Current Transducer Installation and Debugging in Turbine Axis Displacement and Differential Expansion
汽轮机轴向位移、胀差的安装与调试
3.
Design and study of control system for welding roller frame against axial displacement;
防轴向位移焊接滚轮架控制系统的设计与研究
4.
The reason of rupture of driven shaft of idler wheel for some factory is analyzed.
文章分析了某单位移动工位滚轮架从动轴的断裂原因。
5.
grain drive shifter
排种槽轮轴移动机构
6.
Axial limitation of the slevve movement by means of a patented thrust system located in the center line of each gearing.
采用位于每套齿轮中心线的专利推力系统对轴套的位移进行轴向限制。
7.
Close the pivot cover and move the rear wiper blade to the Park position on the ramp.
关闭枢轴盖且移动后雨刷片至在凸轮滑道park（停止）位置。
8.
open 4-wheeled horse-drawn; has seat attached to a flexible board between the two axles.
四轮的马拉的车；座位附属在两个车轴之间的可移动的板上。
9.
Analysis on the Factors influencing the Measuring Result of Axial Displacement of Turbine Generator
影响汽轮发电机轴向位移测量结果的各因素分析
10.
Bring the walking foot as close to presser foot 3 as possible to the extent that it does not come in contact with the rear face of presser foot. Securely tighten screw 2 in the center shaft bell crank.
移动外压脚，一直移动到不能顶到中压脚3的背面的位置，紧紧地拧紧中轴轮紧固螺丝
11.
overspeed and axial displacement trip
超速和轴向位移脱扣
12.
fiber axial displacement sensor
光纤轴向位移传感器
13.
eddy current shaft-displacement and shaft-vibration monitor
涡流式轴位移-轴振动监测仪
14.
Analysis on the TSI positioning optimization of 1 000 MW steam turbine
1000MW汽轮机TSI调整轴系定位法优化分析
15.
Gear A, at the end of the drive shaft, and gear B, on the countershaft, are in constant mesh.
齿轮A位于驱动轴的末端，齿轮B在副传动轴上，它们恒定啮合。
16.
camshaft(journal )turning lathe
凸轮轴（轴颈）车床
17.
Thus a normal loom has two shafts. The main shaft(crankshaft or top shaft) drives the lay mechanism and is geared to another shaft which operates at half of the speed of the crankshaft.
这样,普通织机应具备两根轴,主轴(曲拐轴或位于上部的轴)驱动筘座并通过齿轮驱动另一根轴。
18.
Radial Measurement on the Axial Displacement of AMB Rotor;
电磁轴承转子轴向位移的径向测量研究