1.
Optimal Design of Vibration System Driven by Dual-motor Based on Phase Difference Control
基于相位差控制的双机驱动振动系统优化设计
2.
Research on Offset Optimization about Signalized Coordinated Intersections;
交叉口协调控制相位差优化方法研究
3.
The Design of Offset Fuzzy Controller in Coordinated Control Algorithm
线控制算法中相位差模糊控制器的设计
4.
relative deviation of controlled variable
控制变量的相对偏差
5.
Research of Magnetoelectric Phase Difference Type Torque & Rotational Speed Measuring System Based on DSC;
基于数字信号控制器的磁电式相位差型转矩转速测量系统的研究
6.
DISCUSSION ABOUT THE INFLUENCE OF ESTABLISHING PRECISION PROJECT CONTROL NET AND THE BROADCASTING ATELLITE CALENDAR’S ERROR TO THE ACCURACY OF THE RELATIVE FIXED POSITION
浅谈GPS建立精密工程控制网、广播星历误差对相对定位精度的影响
7.
Analysis of the Transmission Performance of Octal Differential Phase-Amplitude-Shift Keying in High Speed Optical Fiber Communication System
高速光传输系统中八进制差分相位幅度键控性能分析
8.
A new method for restraining the spurious caused by phase truncation in DDS
抑制DDS技术中相位舍位误差的新方法
9.
drum phase control loop
磁头鼓相位控制环路
10.
phase indicator balancing control
相位指示器平衡控制
11.
Control charts for medians and for ranges
GB/T4091.4-1983中位数极差控制图(x-r图)
12.
Measuring and Controlling the Position Error of Bearing Hole in Machining Canular Forked Shaft;
叉头套轴承孔位置误差的测量与控制
13.
Application of Fuzzy Control Theory to Deadbeat Control Scheme in Three-phase Pulse Width Modulation Rectifier
模糊控制在三相PWM整流器无差拍控制中的应用
14.
Study of the FMC Quality Control based of relative Tolerance
基于相对公差法的FMC质量控制研究
15.
The error in azimuth must be controlled by astronomical observations for azimuth(and longit ude).
方位误差必须观测天文方位角（及经度）来控制。
16.
Phase Noise and Power Optimization of a 2-GHz Differential CMOS LC VCO
差分LC压控振荡器相位噪声和功耗的优化
17.
The Design and Study of SIT Inverter Zero Phase-Difference Control System;
SIT逆变器无相差锁相环控制系统设计与研究
18.
Simulation and Analysis of Three-phase Four-wire Four-leg APF with Deadbeat Control
无差拍控制三相四线制四桥臂APF仿真分析