1.
Design of high-current negative-source based on MC34063
基于MC34063的大电流负电源设计
2.
burden error of PT
电源变压器负载误差
3.
Electrified Railway Traction Load Negative Sequence Characteristics and Its Negative Sequence Source Modeling Study
电气化铁路牵引负荷负序特性及负序源建模研究
4.
Ambient negative corona discharge ion source with small line-cylinder electrodes
敞开式小型线-筒电极负电晕放电离子源(英文)
5.
Investigation on Transient Response Performance of Point-Of-Load (POL) Converter;
负载点电源（POL）瞬态响应性能的研究
6.
The SCR Medium Frequency Power Match the Load of 250kw,1kHz.;
250Kw、1kHz可控硅中频电源的负载匹配
7.
Research on Capacitance Load in low-power DC/DC switch power
小型DC/DC开关电源容性负载的研究
8.
The Electrical and echanical Services Department promotes energy efficiency and conservation.
机电工程署负责促进能源效率和推动节约能源。
9.
Use a shielded cable with the high-level source circuit's return current carried in the shield( Figure18).
负载电流较大时，用屏蔽体来充当负载电流返回信号源的通道。
10.
When the unit is ready to accept load, the auxiliary power system is transferred from the start-up to the unit source.
当机组准备带负荷时,厂用电系统从起动电源切换到机组电源。
11.
Do not overload electrical power outlet with multiple connections.
不要超负荷使用多条连线于电器的电源插座。
12.
Design and Development of Power Source Monitoring System for Level Ⅰ Railway Load;
铁路电力一级负荷电源监测系统的研究与设计
13.
Study on Load Detection and System Modeling Simulation for Region Controllable Contactless Power
可分区供电电源负载识别与系统建模仿真
14.
Stability Analysis of More-Electric Aircraft Power System with Parallel Loads
多电飞机电源系统的负载并联稳定性分析
15.
Uninterruptible power supplies (UPS) are often provided to supply power to critical loads such as computers, controls, and monitoring systems.
不间断电源(UPS)通常作为重要负荷,如计算机、控制、监测系统的电源。
16.
This method can also be applied to switch electrical source of inductive load or bring-in spare power supply.
该方法还可以用于感性负载的电源的切换以及备用电源自投入。
17.
The reasonable choice of matching state of voltage source or current source is a common problem in measurement.
与负载匹配状况的合理选择是电压源和电流源经常遇到的问题。
18.
ANALYSIS AND RESEARCH BETWEEN THE OUTPUT GAIN OF THE DIFFERENTIAL AMPLIFIER MITH THE RESISTOR LOAD AND THAT WITH CURRENT SOURCE LOAD
电阻性负载与恒流源为负载的差动放大器放大倍数的分析