1.
The Design of Measurement Circuit for Axis Angle Based on Selsyn Transformer;
基于旋转变压器/自整角机的轴角检测电路设计
2.
Analysis of Inspection and Measuring Method for 120° Distributing Angle Errors of Crankshaft Crankpins
曲轴曲拐120°角度误差检测方法分析
3.
Analysis on Measuring Accuracy in Inspecting Crank Angles for Six-cylinder Crankshafts
六缸发动机曲轴曲拐夹角检测方法的精度分析
4.
Exploiture and Research on the Detection Instrument of the Deflexion-angle of Carrying-axletree of the Semitrailer;
半挂车承载轴偏斜角检测仪的开发研究
5.
Control and test of elevation angle for dual-axis tracking system of horizon coordinates
地平坐标双轴跟踪系统中高度角的控制与检测
6.
Design of Indirect Measuring Tool used to Angle Error of Shaft Part
轴类零件角度误差间接测量检具的设计
7.
The Method of Detecting and Correcting Oblique License Plate Based on the Corner Points Information and Inertial Principal Axis
采用角点信息和惯性主轴的车牌倾斜检测与校正方法
8.
Development of Dynamic-torque Measure System Based on the Cam-turn-angle of Diesel Fuel Pump
基于凸轮轴转角的油泵瞬态扭矩检测系统的研制
9.
Method to Test the Weak Shaft-rate Electric Field of the Ship Based on the Diagonal Slice of FS Polyspectra
基于高阶FS谱对角切片的舰船轴频电场微弱信号检测方法
10.
axonometric(al) drawing
轴测图，不等角投影图
11.
Measurement System of Synchro's Shaft Angle Signal Based on TMS320LF2407
采用TMS320LF2407的自整角机轴角信号测量系统
12.
When taking propeller shaft joint angle measurements, or checking the phasing, of two piece shafts, consider each shaft separately.
当测量两个传动轴的工作角或检查它们是否定相时，对它们要分别考虑。
13.
Opto-axes Parallelism Detection Method for Laser-range-finder Based on CCD
基于CCD的激光测距机光轴平行性检测
14.
Research of visual measuring technical and application of crankshaft forging dimensions measuring
视觉检测技术在曲轴锻件尺寸检测中的应用
15.
The Application of a Single Chip Processor 8098 to Detecting the Axial Clearance of a Bearing
8098单片机在轴承轴向间隙检测中的应用
16.
Research on Axial and Radial Force Testing Technology of Pump Shaft
水泵泵轴轴向力与径向力检测技术研究
17.
Error Calculation for Rotation Axes of Five-axis Machine Tool
五轴数控机床回转轴的误差检测技术研究
18.
Development of Measuring Instrument for Axial Clearance and Assemble Height of Boxcar Bearings
铁路货车轴承轴向游隙及装配高检测装置