1.
Core plasma parameters design and analysis for the fusion driven sub-critical system
聚变驱动次临界堆聚变堆芯参数设计与分析
2.
Activation characteristics of the dual-cooled w aste transmutation blanket for the fusion-driven subcritical system
聚变驱动次临界堆双冷嬗变包层材料活化计算与分析
3.
Analysis of the Effect on Two-dimensional Transport-burnup Calculation of Dual-cooled Waste Transmutation Blanket for the Fusion-Driven Sub-critical System;
聚变驱动的次临界堆燃耗计算二维效应分析研究
4.
Optimization of design parameters based on minimizing the cost of electricity of the fusion-driver sub-critical system;
基于最小化发电成本的聚变驱动次临界堆参数优化分析
5.
Optimization of frequency conversion system in inertial confinement fusion driver for frontally located beam smoothing elements
惯性约束聚变驱动器终端束匀滑器件前置时频率转换系统优化研究
6.
Study on the frontal condition for continuous phase plate in inertial confinement fusion driver
激光惯性约束聚变驱动器终端光学系统中束匀滑器件前置的条件研究
7.
And critically, one that keeps our focus where it needs to be: on driving change.
同样关键的是，它也需要聚焦重点：驱动改变。
8.
Characteristics and Driving Forces Analysis of Residential Area Expansion in the North of Shandong Peninsula Coastal Area;
山东半岛北部海岸带城乡聚落扩展变化特征与驱动力分析
9.
An Out-Of-Plane Eletro-Thermal Polymer Actuator;
聚合物基（SU-8）面外运动电热微驱动器
10.
Individual infinite variable speed drive of each roll with AC-motors coupled to programmable frequency inverters.
电机驱动方式为交流变频无极变速驱动。
11.
An Experimental Study on CDG Flooding Process after Polymer Displacement in LaNan No.1 Block;
喇南一区聚驱后低浓度可动凝胶调驱试验研究
12.
Between 1990-92, through experimentation, thermonuclear fusion reaction was achieved through the method of indirect driving, and thermonuclear neutron was observed.
接着在1990－1992年间通过实验，用间接驱动方式实现热核聚变反应，观察到了热核中子。
13.
DYNAMIC ANALYSIS OF THE SUCKER ROD IN THE POLYMER FLOODING METHOD
用于聚合物驱油的抽油杆动力学分析
14.
A new prediction model on production performance for polymer flooding
一种预测聚合物驱开发动态的新模型
15.
Hydrostatic wheel and travel drive with four-range infinitely variable speeds, anti-slip drive
静液压全轮驱动，四档无级变速，防滑驱动。
16.
The amplitude at the driven end is fixed by the driving mechanism.
由于驱动机构的作用，使驱动端的振幅保持不变。
17.
Research and Implementation of a Combined Focused Crawler Based on Protocol-Driven and Event-Driven Crawling Techniques
基于协议驱动与事件驱动的综合聚焦爬虫研究与实现
18.
Design and Fabrication for Valveless Micropump Driven by Dielectric Elastomer
电致动聚合物驱动的无阀微泵的设计与制作