1.
Failed to Toggle between Remote Control and Chat Mode
在远程控制和聊天模式之间切换失败
2.
Analysis on Handover Failure in GSM System and the Solution
GSM系统中切换失败分析及解决方法
3.
Research on Handover Failure and Optimization of GSM-R Network;
GSM-R网络中越区切换失效和优化的研究
4.
Reason for the Failure of Handover about ZTE Equipment Replace Nortel Equipment,and the Method to Adjustment
浅析中兴设备替换北电设备后切换失败的原因及调整方法
5.
If this kind of circumstance usually took place then system to once carry big, cut over failure but creation to drop words.
这种情况若经常发生则系统负荷过大，切换失败而产生掉话。
6.
There are large handoff latency and the packet being easier to lose on mobile IP handoff.
移动IP切换存在切换延迟大,数据包易丢失的问题。
7.
SWITCHOVERSWITCHOVER:AP A;
切换SWITCHOVER:AP A;
8.
SWITCHOVERSWITCHOVER:RCS A;
切换SWITCHOVER:RCS A;
9.
The following fault conditions can cause an RCS to quick failover:
下列的故障情况会引起 RCS 的快速失败切换：
10.
Analysis of secondary voltage loss caused by 220kV bus voltage switchover
220kV母线电压切换引起二次回路失压事故分析
11.
switching mechanism
开闭[切换，转换，转辙]机构
12.
To&ggle Form/Unit
切换窗体/单元(&G)
13.
To Switchover an APs Applications
切换 AP 应用程序
14.
The ship was wrecked and became a total loss.
船只失事，一切都损失了。
15.
FS Switch to full screen mode. /WM Switch to window mode.
FS切换到全屏模式./WM切换到窗口模式.
16.
If the main device fails, the backup can take over, duplicating all the encryption parameters, that were in force.
如果主设备失灵，备用设备可切换过来，将所有有效的加密参数复制下来。
17.
A maximum of eight RCSs will Quick Failover when and AP goes down and the STANDBY AP comes up.
当AP开始退出而其STANDBYAP开始运行时，最多将有8个RCS进行快速失败切换。
18.
The following programs may cause the version switch operation to fail. It is highly recommended that you close this programs before you continue.
下列程序可能引起版本切换操作失败。建议您在继续操作之前关闭这些程序。