1.
Structure Optimization for Hydrostatic Supporting Bush of Crank Shaft and Rod Type Hydraulic Motor
曲轴连杆式液压马达静压支承连杆瓦结构优化
2.
Research on Camshaft Connecting- Rod Type Low Speed High Torque Hydraulic Motors with High- Pressure Rank;
曲轴连杆式低速大扭矩液压马达的高压化研究
3.
The rod-bearing cap attaches the connecting rod to the crankpin.
连杆轴瓦盖将连杆安装到曲轴销上。
4.
Remove piston and connecting rods from crankshaft journals.
从曲轴颈上拆下活塞和连杆。
5.
The crank end of the connecting rod is sometimes called the rod "big end".
连杆的曲轴有时称为“大头”。
6.
CAE Analysis of Crankshaft and Connecting Rod Mechanism for Motorcycle Engine
摩托车发动机曲轴连杆机构的CAE分析
7.
Dynamic Simulation of Vibration Source of Crankshaft System
发动机曲轴连杆机构振动源仿真分析
8.
An Analysis of the Improvement of Piston-Con Rod-Crank-Shaft of CG125 Engine
CG125发动机活塞连杆曲轴改进分析
9.
The cap and rod have bearings which permit the crankpin to rotate freely within the rod.
轴瓦盖和连杆中有轴瓦，它允许连杆内的曲柄锁自由地转动。
10.
The piston, through the connecting rod, transfers to the crankshaft the force created by the burning fuel mixture.
活塞，通过连杆，与曲轴相连并将燃烧混合气产生的力传给曲轴。
11.
Dynamic Modeling and Analysis for Loose Joint between Crank and Linkage of Membrane Pump
隔膜泵曲轴连杆连接松动动力学建模与分析
12.
Research on Strength and Stiffness of Crankshaft and Connecting Rod Based on Finite Element Method;
基于有限元法的曲轴与连杆强度刚度研究
13.
Study on Diesel Engine Modal Analysis of Crankshaft, Connecting Rod and the Composite Structure
柴油机曲轴、连杆及组合结构模态分析方法研究
14.
Dynamic Analysis and Simulation of the Automotive Air Compressor's Crank-Rod Mechanism
车用空压机曲轴连杆机构的动力学分析与仿真
15.
Kinematic Precision Analysis on Crankshaft Neck of Compound Follow-up Turning System
曲轴连杆颈复合跟随车削系统的运动精度分析
16.
Abstract: The article introduced a grinding method and principle of the journal of crankshaft connecting rod.
本文简述了一种正在兴起的曲轴连杆轴颈的磨削方法和原理。
17.
A new structure for fixing the bearing bush of the connecting lever in a crankshaft press is introduced.
针对曲轴压力机连杆上轴瓦的固定问题，介绍了一种新的固定结构。
18.
The design of a support with eccentricity for turning high-power 9 cylinders diesel engine crank pin
大型9缸柴油机曲轴连杆轴颈车削偏心扶架设计