1.
Mode and Finite Element Analysis of the Centrifugal Pump Bearing Bracket;
离心泵轴承支架的模态及有限元分析
2.
Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;
长轴深井泵轴承支架水力参数的探讨
3.
Study on Application of Hydrostatic Bearing to the Equilibrium of Axial Force of Multistage Centrifugal Pump;
液体静压支承技术在多级离心泵轴向力平衡中的应用研究
4.
The carriage is supported on guide shafts.
托架支承在导轴上。
5.
" Test methods for centrifugal, mixed flow, axial and regenerative pumps"
GB/T3216-1989离心泵、混流泵、轴流泵和旋涡泵试验方法
6.
Research on Sliding Shoes Hydrostatic Bearing of Water Hydraulic Axial Piston Pump;
水压轴向柱塞泵的滑靴静压支承研究
7.
" NPSH for centrifugal, mixed flow and axial pumps"
GB/T13006-1991离心泵、混流泵和轴流泵汽蚀余量
8.
Pump shaft is provided with independent supporting point to ensure dependable running of motor bearing.
泵轴有独立的支撑点，使电机轴承运行可靠。
9.
The top end bracket shall be fitted with a stainless steel lifting bail and shall be capable of supporting the combined weight of the pump and motor.
顶部尾轴承架应该配置不锈钢吊环，应该能够支撑泵和电机的总重量的压力。
10.
The top end bracket shall be fitted with a lifting bail and shall be capable of supporting four (4) times the combined weight of the pump and motor.
顶部尾轴承架应该配置吊环，应该能够支撑泵和电机的总重量四（4）倍的压力。
11.
" Economical operation for industrial centrifugal, mixed flow, axial flow and vortex pump systems"
GB/T13469-1992工业用离心泵、混流泵、轴流泵与旋涡泵系统经济运行
12.
APPROACHES TO PRODUCING A PULSATILE FLOW WITH LOW TURBULENCE FROM IMPELLER PUMP
轴流泵及离心泵产生低扰动搏动流的方法
13.
Research on Meridionai Plane Drawing in the Impeller CAD System of Centrifugal Pump
离心泵叶轮CAD系统轴面绘型的研究
14.
Experimental Study on Magnetic Fluid Seal of Centrifugal Pump
离心泵旋转轴的磁流体密封实验研究
15.
Estimation and Experiment of Axial Thrust in Centrifugal Pump Based on CFD
基于CFD的离心泵轴向力计算与试验
16.
emergency bearing oil pump
紧急备用轴承油泵应急轴承油泵
17.
cageless bearing
无保持架轴承,开口轴承
18.
Fea of the Misalignment of the Centrifugal Pump and Driver Shafts Due to External Load;
离心泵泵嘴载荷对泵轴与电机轴不对心度影响的有限元分析与研究