1.
Study on Dimension Engineering Process Management Using DQ&V and Virtual Methods;
基于DQ&V与虚拟分析优化的尺寸工程管理研究
2.
Dimensional tolerances for plastic engineering moulded plastic pats
GB/T14486-1993工程塑料模塑塑料件尺寸公差
3.
They can be obtained in all the industrial sizes and their metric equivalents.
各种工业尺寸或公制尺寸的胸架都有。
4.
Ergonomics Research on Automobile Cab Based on Human Physical Dimensions of Chinese People
基于中国人体尺寸的汽车驾驶室人机工程研究
5.
The Important Position of Rational Dimensioning in Engineering
尺寸标注的合理性在工程化中的重要地位
6.
The Size Measurement of Welding Gap and Exterior Quality Controlling for the Steel Gate Welding
钢闸门工程的焊缝尺寸检测及外观质量控制
7.
Control Method of Dimension Tolerance in Automatic Programming and Machining
尺寸公差在自动编程及加工中的控制方法
8.
greater in size or importance or degree.
尺寸、重要性或程度大的。
9.
We also can supply the products with customers' wishs and needs.
注：除上述规格尺寸外，也可按用户需要尺寸加工。
10.
It is very important that determine[ color= Red] arbor size[/ color] when planning process of boring on lathe.
在制定车床上镗孔的工艺规程时，镗刀杆尺寸的确定十分重要。
11.
See Engineering Data section for end flange dimensions and drilling templates.
请参阅《工程技术资料》章节，了解法兰尺寸和钻孔模板。
12.
See' Technical Data" section for end flange dimensions and drilling templates.
参阅《工程技术资料》章节，了解连接端口法兰尺寸和钻孔模板。
13.
In-line dynamic mixers are engineered to suit the application (ie. throughput, pipe size, etc.).
管道动力混合器适合于工程配置的应用（如，产量，管道尺寸等）。
14.
Research on the Effect of Process on the Dimensional Accuracy of Rapid Die Molding Products;
工艺过程对快速模具成型制品尺寸精度的影响研究
15.
Dimension Maturity Check-up and Automatic Calculation to Engineering Drawing Based on Restriction Theory and CR Graph;
基于约束原理和CR图的工程图尺寸信息完备性检验和自动计算
16.
NOTICE: The dimensions shown on the attached dwgs for ball are the finished (after final machining) dimensions; your rough machined forging must guarantee these final dimensions.
注：附件球体图纸上的尺寸为机加工后的最终尺寸，你们的粗加工锻件必须保证这些最终尺寸。
17.
full size drawing
原尺寸图，实物尺寸图
18.
foot in the door technique
得寸进尺法得寸进尺法