1.
Study on the Atomizing and Humidifying Character of the Centrifugal Nozzle with Firing Pin Type, High Pressure and Little Aperture;
撞针型高压小孔径离心式喷嘴雾化加湿性能的研究
2.
high pressure nozzle spray drier
高压喷嘴式喷雾干燥机
3.
A high-velocity fluid stream forced under pressure out of a small-diameter opening or nozzle.
喷射流体在压力迫使下从小喷嘴或小孔中喷出的高速流体
4.
aperture atomizer
喷孔式喷油嘴喷雾器
5.
diameter and number of hole
喷嘴量孔孔径及数目
6.
Measure Methods of Spray Distribution in Radial Direction of Pressure Atomization Nozzle
压力式雾化喷嘴径向喷淋密度的测量方法
7.
Testing Research on Load Characteristic of Large-capacity ZD Model CWS Atomizer
大型撞击式水煤浆喷嘴流量特性试验研究
8.
Numerical study on spray angle of the dual-orifice pressure-swirl atomizer
双路离心式喷嘴雾化锥角的数值研究
9.
Theoretical analysis of dynamics of open swirl injector
敞口型离心喷嘴动力学特性理论分析
10.
Numerical Simulation of Torpedo Centrifugal Atomizer Spray Field
鱼雷离心式喷嘴喷雾场的数值模拟研究
11.
Droplet Size and Droplet Size Distribution of Y-Type Air-Blast Nozzle
Y型气流式喷嘴的雾化滴径和滴径分布
12.
CAVITATION MODEL FOR THE LOW-PRESSURE LARGE-DIA SELF-EXCITED PULSE NOZZLE
低压大直径喷嘴自激脉冲射流空化模型
13.
Flow characteristics of radial jet from two opposed jets
两喷嘴对置撞击流径向射流流动特征
14.
VOF-Based Numerical Simulation of Two-Phase Flow in Swirl Atomizer
基于VOF方法数值模拟离心式喷嘴内两相流流动
15.
Reduce pressure. Use a larger nozzle. Hold spray gun closer to the surface. Spray at right angles to the surface.
改变压力。使用大一点的喷嘴。加近喷枪与底材的距离。调整高度。
16.
Finite Element Analysis on 3D Flow in the Nozzle and Shock Stress of the Needle in Diesel Engine Injector;
柴油机喷油嘴三维流场及针阀碰撞有限元分析
17.
Test results show that the corona's onset and breakdown voltage both rise with increasing OD of the nozzle.
结果表明:喷嘴外径增大,起晕电压和击穿电压升高。
18.
A perforated nozzle for spraying water from a hose or sprinkling can.
莲蓬式喷嘴一种使水从管子或喷水壶里喷洒出来的有孔的喷嘴