1.
Research on the Law of Influence of Geometric Technology Parameters on Axis-Thrust Tube Bending Process;
几何工艺参数对热推弯管过程影响规律的研究
2.
Study on Motion Simulation and Working Procedure Planning for NC Tube Bending;
数控弯管过程运动仿真与工序规划技术
3.
Study on spring-back compensation for non-plane tube bending process
非平面弯管成形过程的回弹补偿研究
4.
Research on Optimization in Precision NC Bending Process of Thin-Walled Tube;
薄壁管数控弯曲精确成形过程参数优化研究
5.
A Research on Modeling of Tube Bending Process and Process Planning System;
导管弯曲工艺过程建模与工艺规划系统研究
6.
Numerical Simulation and Experimental Verification of Two-Layered Tube Bending;
金属复合管弯曲过程数值模拟与实验验证
7.
FEM Simulation of Roll Forming Process for Air Duct Flange
风管共板法兰辊弯成形过程的有限元仿真
8.
The process of curving or the condition of being curved.
拱形弯曲的过程或被弯曲的状态
9.
Numerical Simulation of Wrinkling Onset during the NC Bending Process of Thin-walled Tube;
薄壁管数控弯曲成形过程失稳起皱的数值模拟研究
10.
Research on Wrinkling and Forming Limit of NC Bending Process of Thin-Walled Tube;
薄壁管数控弯曲成形过程失稳起皱及成形极限的研究
11.
P: Turn & slip indicator ball stuck in center during turns.
在转弯过程中，转弯侧滑仪小球保持在中间不动。
12.
Analytic Quantitative Descriptive Model of Intellectural Bending Process;
智能化折弯过程的解析定量描述模型
13.
Numerical simulation of multi-pass roll forming process of anode plate
阳极板多道次辊弯成形过程数值模拟
14.
The numerical simulation of hollow i-beam forming process based on ANSYS/LS-DYNA
空心工字钢冷弯成型过程的数值模拟
15.
Effect of Entrance/exit Leveler Roller' intermesh to Plate Flatness
辊式矫直过程中板带弯曲挠度的确定
16.
As you are turning toward the apex, you need to be above the ideal corner speed slightly, scrubbing it off as you get to the apex.
你开始转向弯心的时间，需要比理想过弯速度稍高，在达到弯心的过程中，摩擦力使你减速。
17.
Interface Slip and Full Process Analysis of Double Steel-Concrete Composite Beam under Negative Bending;
钢－混凝土双面结合梁负弯矩区滑移及受弯全过程分析
18.
plication amnagement application process
应用过程管理应用过程