1.
Secant Stiffness Method Research Based on 2D Non-linear Finite Element of Reinforced Concrete;
钢筋混凝土二维非线性有限元分析的割线刚度法研究
2.
The Design of NC Revolving Platform and Dividing Control Card Used in Five-axis WEDM for Diamond Milling Cutters;
金刚石铣刀五轴线切割数控回转台及分度控制卡的设计
3.
Method for Low Contrast X-ray Image Segmentation Based on Gradient
基于梯度的低对比度X线图像分割方法
4.
Two-dimensional Cross-entropy Linear-type Threshold Segmentation Method for Gray-level Images
灰度图像的二维交叉熵直线型阈值分割法
5.
taper wire-cut EDM machine
锥度电火花线切割机床
6.
Identification of weak nonlinearities in damping and stiffness based on wavelet transform
基于小波变换的弱非线性阻尼和刚度辨识方法
7.
Influence of diamond concentration,grit size and hardness on the performance of diamond saw blade
金刚石浓度、粒度和强度对锯片切割性能的影响
8.
hot-wire cutting
(平板玻璃的)热金属丝切割法，火线切割
9.
Study on Electroplated Diamond Wire Saw Slicing Single Crystal Silicon Technology and Mechanism
电镀金刚石线锯切割单晶硅技术及机理研究
10.
Study on the Machining Performance of Single Crystal Silicon Wafer Cut by Using Reciprocating Electroplated Diamond Wire Saw
往复式电镀金刚石线锯切割单晶硅片特性研究
11.
Anti-jamming Performance Evaluation of Linear Frequency-modulated Continuous Wave Fuze Based on Ambiguity Function Incision
基于模糊函数切割法的线性调频连续波引信抗干扰性能测度
12.
Research on Super-large Thickness Machining Technology of WEDM;
电火花线切割超大厚度切割技术的研究
13.
COMPUTER CONTROL OF MAIN ROLLING LINE IN COLD STRIP MILL AND METHOD FOR GAGE CONTROL BY DYNAMICALLY SUPPOSED DEFORMATION STIFFNESS APPRAISED
冷连轧主轧线计算机控制和动态设定型变刚度厚控方法通过鉴定
14.
Modeling Methodology of Milling Deflection and Flexible Milling Force for Tooth Profile of Low-rigidity Cycloid Gear in High Speed Milling
低刚度摆线轮缘高速铣削变形与铣削力建模方法
15.
Study on contact stiffness factor selection method in contact non-linear simulation
接触非线性仿真中接触刚度因子选取的方法研究
16.
Method to Enhance the Stiffness of Cable-suspended Structure for Super Antenna and Its Effect on the Electronic Performance
提高超大型天线索支撑结构刚度的方法及其对电性能的影响
17.
Abstract： This paper focuses on the synchronization of line speed among multi-axes of line cutter, provides the solution and control principle diagram.
本文针对线切割机多轴之间的线速度同步控制，提供一套解决的方法，并给出控制原理图。
18.
A Basic Study on the Relation between Wire Diameter and Wafer Warp
多线切割工艺中切割线直径对翘曲度影响的研究