1.
starch dropped goods
用淀粉模型浇注成形的糖果
2.
Study on Strength Properties of Phosphate Bonded Core Used in Investment Cast and Formed by Pouring
熔模铸造用浇注成形磷酸盐粘结型芯强度研究
3.
Research on the Performance and Analysis on the Technologic Characteristic in Investment Casting of Phosphate Self-setting & Formed by Pouring Materials;
磷酸盐浇注成形芯料性能及工艺应用实验研究
4.
The series of current transformers are resin insulated， fully enclosed and busbar type. The iron core is circular and the secondary winding goes around the core before casting by epoxy.
本型电流互感器的铁心为圆环形，二次绕组匀绕制在铁心圆周上，用环氧树脂混合料浇注成形。
5.
Design of Running System of Cylinder Block and Simulation of the Forming Process
气缸体浇注系统的设计与成形过程的模拟
6.
The Simulation of the Micro-Part's Weld Lines by Injection Molding;
对微注射成型浇注系统与微制件熔接缝形成的CAE模拟研究
7.
after a metal is cast into ingot, it needs to be further worked into forms and shapes for commercial uses.
金属材料浇注成锭后，还需进一步加工成各种形状，才能用于工业。
8.
Influence of Product Shape and Injection Gat Location on Breakthrough Phenomenon of Core Melt in Co-injection Molding
制品形状和浇口位置在共注射成型中芯层熔体前缘冲破的影响
9.
The Effect of Casting Temperature on Continuous Rheo-Extrusion of AZ31 Alloy based on Numerical Simulation
基于数值模拟的AZ31镁合金连续流变成形浇注温度的影响
10.
The linearis monitoring under skew continuous box girder bridges cast with balanced cantilever method
悬臂浇注斜交连续箱梁桥的线形监控
11.
Study on Gating System of Aluminium Alloy Shell Casting Based on CAE
基于CAE铝合金壳形件浇注系统的研究
12.
"In autumn, 3 m of rough concrete work was completed in the east tube per week."
秋季在东孔每周完成浇注混凝土3米。
13.
The Study of Optimizing the Numerically Simulated Algorithm and the Placement of the Gate in Injection Molding;
注塑成型数值模拟与浇口优化的研究
14.
Freeze Casting of Reaction Bonded Silicon Carbide;
反应烧结碳化硅坯体的冷凝浇注成型
15.
Manufacture of pouring-formed Si_3N_4-SiC articles
浇注成型Si_3N_4-SiC制品的研究
16.
Introduction of fluids into a cell by invagination of the cell membrane, followed by formation of vesicles within the cells.
胞饮作用，饮液作用，否饮作用通过往凹细胞膜中灌浇液体注入细胞中，随着形成细胞内的细胞泡
17.
Top pouring is the simplest and cheapest method, but gives poor control over the rate of pouring.
上注法最简单，成本最低，但不好控制浇注速度。
18.
Application of CAE in the Design of Runner System for Thin Plastic Shell Injection Molding;
CAE在薄壳件注塑成型浇注系统设计中的应用